基于UMAC加工非球面光学零件PVT控制轨迹研究  

Research on PVT Control Trajectory of Processing Aspheric Optical Parts Based on UMAC

作　　者：孔繁星[1,2] 于正林[1] 朴承镐[1] 耿振野[1] 

机构地区：[1]长春理工大学,长春130022 [2]吉林化工学院,吉林132022

出　　处：《长春理工大学学报（自然科学版）》2009年第2期204-206,196,共4页Journal of Changchun University of Science and Technology(Natural Science Edition)

基　　金：国家自然科学基金资助项目(50775014)

摘　　要：本文论述了基于UMAC运动控制卡的控制系统构成,阐述了切线回转法加工非球面光学零件的基本原理,针对常用的非球面光学零件子午剖面曲线方程,给出了基于UMAC运动控制卡加工非球面光学零件PVT控制轨迹形成的具体计算方法,并计算出了三轴联动系统中各轴的运动轨迹方程,运用MATLAB对各轴的位移-时间关系和速度-时间关系进行了仿真,同时将各轴的位移-时间关系曲线和速度-时间关系曲线做了对比分析,从而得出了采用UMAC运动控制卡的PVT控制算法加工任意非球面面型的方法。This article discusses structure of control system based on UMAC motion control card, and basic principle of processing aspheric optical parts by using tangent rotary method. Aiming at common meridian profile curve equation ofaspheric optical parts, a concrete calculation method of PVT control trajectory is presented, which is based on UMAC motion control card and applied for processing aspheric optical parts. The motion trajectory equation of each axel in tri-axial linked system is obtained through this method. Through simulating displacement-time and speed-time of each axel by using MATLAB, and at the same time comparing and analyzing curves of displacement-time and speed-time, then obtain the method of processing arbitrary aspheric surface by using PVT control algorithm of UMAC motion control card.

关 键 词：控制轨迹 切线回转法 非球面 

分 类 号：TG580.1[金属学及工艺—金属切削加工及机床]