BMI-QC130双马树脂拉挤工艺  

Pultrusion process of the bismaleimide resin BMI-QC130

作　　者：李勇[1] 肖军[1] 谭永刚[1] 原永虎[1] 

机构地区：[1]南京航空航天大学材料科学与技术学院,南京210016

出　　处：《复合材料学报》2009年第5期20-26,共7页Acta Materiae Compositae Sinica

基　　金：军品配套项目(JPPT-1146)

摘　　要：为了研究分析双马树脂的拉挤工艺特性和工艺参数,采用差示扫描量热法(DSC)研究了BMI-QC130双马树脂的固化反应动力学,建立了该BMI树脂的固化度预测模型,通过该预测模型得到的固化度预测值与试验值较为吻合,采用双Arrhenius方程建立了该BMI树脂的黏度预测模型,该黏度预测模型在温度低于120℃范围内具有很高的预测精度。根据所建立的固化度预测模型和黏度预测模型确定了BMI-QC130双马树脂的拉挤工艺参数为:胶槽恒温95℃,拉挤模具温度控制在200℃,出模后经过温度为280℃的烘道进行后固化。在此工艺条件下,成功地连续拉挤出碳纤维增强BMI-QC130复合材料样品。To analyze and study the process parameters of bismaleimide resin with pultrusion process,the curing reaction kinetics of the bismaleimide resin BMI-QC130 was studied with DSC analysis.The curing degree prediction model was established,and the predicted values are well coincident with the test values.The viscosity prediction model was established by the dual-Arrhenius equation to predict the resin rheological behavior of the BMI resin system,which has a good prediction precision when the temperature is lower than 120℃.Based on the analysis results of the curing degree model and the viscosity model,the pultrusion process parameters of the bismaleimide resin BMI-QC130 are determined： the resin is melted at 95℃ in the resin bath,precured at 200℃ in pultrusion mould and postcured at 280℃ in hot tunnel.The carbon fiber reinforced BMI-QC130 composite samples are successfully manufactured with the pultrusion process under such process conditions.

关 键 词：双马来酰亚胺树脂 拉挤工艺 反应动力学 流变特性 固化度 

分 类 号：TB332[一般工业技术—材料科学与工程]