立辊侧压量优化策略在提高中厚板成材率中的应用  

Application of Edging Draught Optimization Strategy to Increasing Rolling Yields in a Plate Mill

作　　者：丁敬国[1] 曲丽丽[2] 杨翠英[3] 胡贤磊[1] 刘相华[1] 

机构地区：[1]东北大学轧制技术及连轧自动化国家重点实验室,辽宁沈阳110004 [2]沈阳鼓风机通风设备有限责任公司,辽宁沈阳110041 [3]四川机电职业技术学院,四川攀枝花617000

出　　处：《钢铁研究学报》2010年第11期6-10,共5页Journal of Iron and Steel Research

基　　金：国家自然科学基金资助项目(50104004)

摘　　要：分析了在中厚板轧制展宽阶段和精轧阶段不同的展宽比和伸长率对宽度偏差及切头尾长度的影响,提出了针对不同的展宽比和伸长率条件下的立辊压下量优化方法,以产品长宽比等于10.26为临界点确定得到一个最小切损量的最优立辊压下量。实际应用表明,该方法可将产品的切损率降低15%以上,大大提高了中厚板产品的成材率。The analysis of influence to crop length and width deviation by different broadside rolling ratio and longitudinal rolling ratio in broadening phase and finish rolling phase in plate mill was developed. As to different broadside rolling ratio and longitudinal rolling ratio, an optimization method of edging draught was put into forward, in which optimal edging draught was confirmed so as to obtain minimum trimming loss by the stagnation point as aspect ratio equal to 10.26. From actual application it shows that this method can decrease product trimming loss by more than 15% , and it can increase plate product yields greatly.

关 键 词：中厚板 立辊 成材率 优化 

分 类 号：TG335.5[金属学及工艺—金属压力加工]