基于广义多项式假设模态法的大型螺纹旋风铣削工件系统动力学分析  

Dynamic Analysis of Large-scale Screw system under Whirling Based on

作　　者：张春建[1] 王禹林[1] 韩军[1] 冯虎田[1] 

机构地区：[1]南京理工大学机械工程学院,南京210094

出　　处：《组合机床与自动化加工技术》2011年第11期25-28,共4页Modular Machine Tool & Automatic Manufacturing Technique

基　　金：国家自然科学基金(51105208);国家科技重大专项(2009ZX04001-171-02);中国博士后科学基金(20110491426);江苏省博士后科学基金(1101082C)

摘　　要：文章以大型螺纹旋风铣削的工件装夹系统为研究对象,将铣床卡盘、浮动支撑、抱紧装置,以及尾架简化为弹性约束,并将切削力假设为周期性"半正弦"激励信号,运用广义多项式模态假设法,建立了大型旋风铣削工件系统的动力学模型。基于Matlab编程平台,利用Runge-Kutta法对系统的动力学模型进行数值分析,以研究大型螺纹工件的浮动支撑、抱紧装置对螺纹动态响应的影响。分析结果表明:工件的动态响应是由系统固有特性与切削力特性共同决定,而且抱紧装置对工件动态响应影响显著。当引入抱紧装置后,只需选取较小的浮动支撑刚度就能有效的降低切削点处的动态响应。This paper takes the supporting system of a large-scale screw whirling as the research object,to study its dynamic response.The screw workpiece supported by chuck,floating rest,hold device,and tailstock is simplified to a flexible beam with elastic bearings,and the cutting force is assumed to be cyclical ＂half-sine＂ excitation signal.The kinetic system equations are derived based on Generalized Polynomial Assumed Mode Method,and are solved by the Runge-Kutta method using Matlab to analysis the effect of stiffness of the floating rests and hold devices.The numerical results show that the deflection of screw significantly decreases due to the existence of hold devices.Contrast the dynamic response of the cutting point in two conditions,having and no hold devices,we can found that when introduced into dynamic hold device,just select small floating rest stiffness can effectively reduce the maximum of dynamic response,and dynamic response of the workpiece is determinated by the inherent characteristics of system and the cutting force.

关 键 词：广义多项式假设模态法 螺纹旋风铣削 动力学分析 

分 类 号：TH122[机械工程—机械设计及理论]