检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:刘锋[1] 徐会法[1,2] 陶然[3] 王越[3]
机构地区:[1]海军航空工程学院电子信息工程系,烟台264001 [2]国防大学信息作战与指挥训练教研部,北京100091 [3]北京理工大学信息科学技术学院,北京100081
出 处:《中国科学:信息科学》2012年第2期138-150,共13页Scientia Sinica(Informationis)
基 金:国家杰出青年科学基金(批准号:60625104);国家部委预研项目(批准号:41001020201;11002040105)资助项目
摘 要:在分数阶Fourier域内,当多分量线性调频(LFM)信号的初始频率和调频率相近时,信号的尖峰会出现无法分辨的现象,导致目标信号漏检.文中分析了LFM信号在分数阶Fourier域的频谱分布特征,以及离散分数阶Fourier变换计算条件下LFM信号的频谱分布特征.推导了两个LFM信号在分数阶Fourier域的临界分辨距离,以及两个LFM信号尖峰之间的距离与量纲归一化因子的变化关系,发现选择合理的量纲归一化因子可以增大两个信号尖峰之间的距离.文中提出一种量纲归一化因子优化选择的方法,该方法可以提高分数阶Fourier变换对多分量LFM信号的分辨能力.最后,仿真结果验证了该方法的有效性.When the initial frequencies and chirp-rates of multi-component linear frequency modulation (LFM or chirp) signals are close, in the fractional Fourier domain (FRFD), the phenomenon may occur that the peaks of multi-component LFM signals can't be distinguished. It results in some target signals undetected. In this paper, firstly, the spectrum distribution characteristics of a continuous LFM signal in FRFD are analyzed, and the spectrum distribution characteristics of a discrete LFM signal in the discrete FRFD are also analyzed. Secondly, the critical resolution distance between two LFM signals in the FRFD is deduced, and the relationship between dimensional normalization parameter and the distance between two LFM signals in the FRFD is also deduced. It is discovered that selecting a proper dimensional normalization parameter can increase the distance. Finally, a method to select the dimensional normalization parameter is proposed, which can improve the resolution ability of the FRFT for the multi-component LFM signals. And its effectiveness is verified by the simulation results.
关 键 词:分数阶FOURIER变换 LFM信号 频谱特征 信号分辨 量纲归一化
分 类 号:TN911.7[电子电信—通信与信息系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.31