检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]国防科技大学机电工程与自动化学院,湖南长沙410073
出 处:《国防科技大学学报》2012年第4期143-147,共5页Journal of National University of Defense Technology
基 金:湖南省研究生科研创新项目(CX2011B013);国防科技大学优秀研究生创新资助项目(B110302)
摘 要:当非晶丝巨磁阻抗效应(Giant Magneto-Impedance,GMI)磁探头输出数据的信噪比小于0时,常规的峰值检波方法难以检出真实信号。为此,提出了一种新的微弱信号检测方法,将非晶丝GMI磁探头的输出信号经放大、滤波和采样之后直接送入数字信号处理系统,利用小波变换方法提取微弱信号的特征,并利用相关分析法确定信号的大小。仿真结果表明,采用小波变换和相关分析相结合的方法,可检出信噪比达到-15dB时的弱磁信号。Traditional peak detecting method is impossible to detect actual signals when the signal-to-noise ratio (SNR) of the output of a giant magneto-impedance (GMI) probe is less than 0dB. A novel method, therefore, is presented to detect weak signals from the probe, which are directly sent to digital signal processing system after signal conditioning and sampling. In this method, the characteristics of the weak signals are extracted by wavelet transform and the amplitudes determined by the correlation method. The simulation results indicate that the probe' s output signals with SNR = - 15dB can even be detected by the hybrid method mentioned above.
关 键 词:GMI磁传感器 微弱信号检测 小波分析 相关分析
分 类 号:TN911.7[电子电信—通信与信息系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117