Y型异径三通管热态内高压成形研究  

Simulation of Y-shaped Reducing Tee During Warm Hydroforming

作　　者：梁晓辉[1] 余心宏[1] 索小琳[1] 

机构地区：[1]西北工业大学材料学院,陕西西安710072

出　　处：《金属功能材料》2012年第6期29-34,共6页Metallic Functional Materials

基　　金：国家自然科学基金资助项目(51075333)

摘　　要：基于Dynaform软件平台,建立了Y型异径三通管三维弹塑性有限元模型。运用数值模拟方法,研究了AZ31镁合金Y型异径三通管热态内高压成形过程、成形缺陷、等效应变分布。探讨了初始管坯长度、左右冲头轴向进给量与成形支管高度之间的关系;研究得到了相同支管长度下成形不同Y型夹角三通管所需的左右冲头进给量。结果表明:随着初始管坯长度减小,支管高度随之增加;在左右进给量相同的情况下,左侧金属流向支管阻力更小,支管高度增加明显;随着Y型夹角的增大,右侧冲头进给增加,轴向补料比减小,总补料比增加,当夹角为90°时,左右补料相同。Based on Dynaform software environment, a 3D elastic-plastic finite element model for Y-shape reducing tee was established. With numerical simulation, the warm hydroforming process of AZ31magnesium alloy Y-shaped reducing tee, failure behavior, forming defects , the equivalent plastic strain distribution during forming were stud- ied. The effects of the initial tube length and the axial feed of punches on the protrusion height were investigated by numerical simulation. The axial feed distances of punches for Y-shapes of the different protrusion height angles were determined. The results show the shorter is the tube length, the greater is the protrusion height formed. The feed distance of left punch influenced more remarkable than right punch on the protrusion height if the same increment of feed distance is set. The axial feed ratio decreases, the axial feed of the right punch increases and the total feed ratio increases with the increasing protrusion angle. When the protrusion angle is 90°, the axial feed of the right and left punch is equal .

关 键 词：Y型异径三通管 支管高度 支管夹角 轴向进给 管坯长度 

分 类 号：TG39[金属学及工艺—金属压力加工]