配分时间对低碳高强Q&P钢组织及力学性能影响  被引量:11

Effect of Partitioning Time on Microstructure and Mechanical Properties of Low Carbon High Strength Q&P Steel

在线阅读下载全文

作  者:陈连生[1] 赵远[1] 田亚强[1] 宋进英[1] 魏英立[1] 杨栋[1] 

机构地区:[1]河北联合大学河北省现代冶金技术重点实验室,河北唐山063009

出  处:《热加工工艺》2013年第20期63-66,共4页Hot Working Technology

基  金:国家自然科学基金资助项目(51254004)

摘  要:在普通C-Mn-Si系Q&P钢的成分基础上,设计了一种低碳的Q&P钢种,并通过金相显微镜、场发射扫描电镜、X射线衍射仪和拉伸实验等对低碳Q&P钢的组织性能以及配分时间对低碳Q&P钢组织性能的影响进行了研究。结果表明:实验用钢经过Q&P处理后,在配分时间为30 s时得到最佳的力学性能,抗拉强度为1340 MPa,伸长率为20%,强塑积达到最大26800 MPa·%;随配分时间的延长,抗拉强度和伸长率均逐渐降低;残余奥氏体含量在配分时间为30 s时达到最大值9.3%,随配分时间的延长,残余奥氏体量逐渐降低。The C-Mn-Si Q&P steel with a low-carbon was designed on the basis of traditional Q&P steel, the microstructure and properties of low-carbon Q&P steel and effects of partition time on the microstructure properties of low-carbon Q&P steel were studied by means of OM, SEM, XRD and tensile tests. The results show that experimental steel gets the best mechanical properties in the partition time 30 s after Q&P processing, tensile strength is 1340 MPa, elongation is 20%, strong plastic product reaches the maximum 26800 MPa. %; with the increase of the partition time, tensile strength and elongation decrease gradually; retained austenite content reaches the maximum 9.3% in the partition time 30 s, with the increase of the partition time, the amount of residual austenite decreases gradually.

关 键 词:配分时间 Q&P钢 残余奥氏体 组织性能 强塑积 

分 类 号:TG156.3[金属学及工艺—热处理]

 

参考文献:

正在载入数据...

 

二级参考文献:

正在载入数据...

 

耦合文献:

正在载入数据...

 

引证文献:

正在载入数据...

 

二级引证文献:

正在载入数据...

 

同被引文献:

正在载入数据...

 

相关期刊文献:

正在载入数据...

相关的主题
相关的作者对象
相关的机构对象