基于Pro/E与ADAMS的数控实验平台的虚拟样机设计仿真  

Design and Simulation of Virtual Prototype of NC Experimental Platform Based on Pro/E and ADAMS

作　　者：毕俊喜[1] 任昭[1] 田春雨[1] 

机构地区：[1]内蒙古工业大学机械学院,内蒙古呼和浩特010051

出　　处：《机械研究与应用》2015年第3期67-68,共2页Mechanical Research & Application

基　　金：内蒙古自然科学基金资助(编号:2012MS0731);内蒙古工业大学机械学院三轴数控运动平台自制设备研制(编号:102-611005)

摘　　要：介绍了三轴数控实验平台的发展情况,并在三维建模软件Pro/Engineer 5.0中根据已购设备参数建立虚拟样机,并用ANSYS对平台关键部分进行静力学分析,最后将模型导入动力学软件ADAMS中进行仿真分析,根据工作台的运动情况验证虚拟样机的合理性,为数控平台的设计提供参考方法。In this article, the development of three-axis numerical control（NC） experimental platform is introduced, and thevirtual prototype is also set up in the 3d modeling software Pro/ Engineer 5. 0 according to the parameters of equipments whichalready bought. Then the statics analysis about the key part of platform is conducted by using ANSYS, and finally the simula-tion analysis is made by importing the model into the dynamics software ADAMS. According to the movement of workbench,the rationality of the virtual prototype is verified, thus could provide reference methods for the design of NC platform.

关 键 词：ANSYS 数控 虚拟样机 ADAMS 

分 类 号：TH138[机械工程—机械制造及自动化]