检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李冬宁[1,2] 王成龙[1] 王丽秋[1] 郭同健[1]
机构地区:[1]中国科学院长春光学精密机械与物理研究所,吉林长春130033 [2]中国科学院大学,北京100049
出 处:《中国光学》2015年第3期456-463,共8页Chinese Optics
基 金:吉林省自然科学基金资助项目(No.201115124)
摘 要:介绍了地基测量空间目标光度的两种方式。首先介绍了系统组成及对比测量原理,然后基于工程角度分析提出了宽谱段测量和滤光片测量两种方式,并给出了两种测量方式的误差分析。若G型恒星及空间目标在同一视场可选择宽谱段测量方式,若途经天区G型定标星较少,可以选择滤光片测量方式。外场实验验证表明,宽谱段测量方式信噪比较高,可探测的极限星等为16等星,在天气条件较好的情况下测量精度在0.15星等左右,而滤光片测量方式由于探测到的能量较少,在相同信噪比下可探测极限星等为14等星,天气变化较小条件下测量精度在0.02星等左右,两种测量方式误差相当,但宽谱段测量方式定标恒星数量增加2.4倍,便于数据处理与计算。In order to realize photometric measurement, two types of measurement way are established.First, the system composition and the contrast measurement principle are introduced, and then wide spectrum meas-urement way and filter measurement way based on the analysis of engineering are proposed.If G-type stars and space target in the same field of view, the wide spectrum measurement way can be chosen;if G-type reference stars is less, filter measurement way can be chosen;measuring error analysis for these two ways is given.Fi-nally experimental results indicate that the wide spectrum measurement way has high signal noise ratio( SNR);the limiting magnitude is 16 mv , and the measurement precision can reach 0.15 magnitude under better weath-er condition;under the same SNR condition, due to the less energy detected by filter measurement way, limit magnitude is 14 mv; under the condition of small weather changes, measurement precision can reach 0.02 magnitude.Two types of measurement errors are almost the same, but the number of stars calibrated by the wide spectrum measurement way increases by 2.4 times, which is advantageous for the data processing and calculation.
分 类 号:V556[航空宇航科学与技术—人机与环境工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.229