刮板输送机系统机电耦合模型及仿真分析  

Electromechanical Coupling Modeling and Simulation Analysis of Scraper Conveyor System

作　　者：张强[1,2] 王海舰[1] 毛君[1] 刘占胜[3] 

机构地区：[1]辽宁工程技术大学,阜新123000 [2]大连理工大学工业装备结构分析国家重点实验室,大连116023 [3]中国煤矿机械装备有限责任公司,北京100011

出　　处：《中国机械工程》2015年第23期3134-3139,共6页China Mechanical Engineering

基　　金：国家高技术研究发展计划(863计划)资助项目(2013AA06A412);高等学校博士学科点专项科研基金资助项目(20132121120011);工业装备结构分析重点实验室开放基金资助项目(GZ1402);辽宁省高等学校杰出青年学者成长计划资助项目(LJQ2014036)

摘　　要：根据刮板输送机机械系统与控制系统之间的耦合关系,推导出刮板输送机的非线性状态空间机电耦合方程,采用MATLAB/Simulink模块建立刮板输送机的仿真模型,对刮板输送机系统的机电耦合动力学问题进行仿真和研究;采用等效变化载荷质量分析刮板输送机在空载启动、平稳运行、载荷突增以及卡链工况下的刮板链速度、电磁转矩的特性曲线,得到了启动时两链轮的转角曲线。结果表明,驱动链轮与从动链轮启动时转角差约为85°,从动链轮启动旋转较驱动链轮滞后约0.8s。研究结果为研究刮板输送机不同工况、载荷下的转矩、速度变化以及计算链轮张紧度提供了理论和数值依据。According to the coupling relationship between the mechanical system and control sys-tem of scraper conveyor,the nonlinear state space electromechanical coupling equations were derived for scraper conveyor,the simulation model of the scraper conveyor was established by using MAT-LAB/Simulink module,the electromechanical coupling dynamics of the scraper conveyor system was studied,the equivalent load change of mass was used to analyse the scraper conveyor’s scraper chain speed and electromagnetic torque characteristic curves in no-load start,stable operation,load surge and card chain condition.Two sprockets’angle curves were obtained at startup,the results show that, the start angle difference between drive sprocket and the driven sprocket is about 85°,the driven sprocket lag about 0.8 s than that of drive sprocket when it rotates.It is provided the theoretical and numerical basis for studying scraper conveyor’s torque,speed change and calculation of sprocket’s pretension in different working conditions and loads.

关 键 词：刮板输送机 机电耦合 刮板链速度 电磁转矩 转角 

分 类 号：TP273[自动化与计算机技术—检测技术与自动化装置]