发射箱用RTM树脂体系工艺性与固化性能研究  

Process and Curing Properties of RTM Resin System for Launch Box

作　　者：徐淑权[1] 黄立果 蔡建[1] 秦旭锋[1] 白焘 汪道全 

机构地区：[1]中国兵器工业第五九研究所,重庆400039 [2]西北工业集团有限公司,西安710043

出　　处：《包装工程》2016年第1期115-119,共5页Packaging Engineering

摘　　要：目的研究环氧树脂体系的黏度及固化性能，为利用树脂传递模塑（RTM）工艺制造发射箱提供理论依据。方法采用旋转黏度计测试了E-51环氧树脂体系的动态黏度和静态黏度，用非等温DSC法和平板小刀法研究了树脂体系的固化行为。结果在60～80℃下70min，树脂体系的黏度仍小于1000mPa·s，符合工艺要求，并推导出了固化温度参数分别为60，125，180℃，以及凝胶时间与温度的关系方程。结论温度区间60～80℃可作为发射箱RTM工艺的操作区间，建议固化工艺制度为60，90．125℃下分别加热固化3．5，2，1h，后处理工艺为180℃下加热固化1h。The aim of this work was to study the viscosity and curing properties of epoxy resin system, in order to provide a theoretical basis for manufacturing launch box using RTM process. The dynamic viscosity and static viscosity of the E-51epoxy resin system were tested by rotational viscometer. The curing behavior of the resin system was studied using the non-isothermal DSC method and Flat knife method. The viscosity of the resin system was still less than 1000 mPa. s after 70 min at 60～80 ℃, which met the process requirements. And it was deduced that the curing temperature parameter was 60, 125 and 180 ℃ respectively, as well as the relationship equation of gel time and temperature. The temperature range 60～80 ℃ could be used as the operating range for RTM process to manufacture launch box. The recommended curing process of system was heat curing 3.5, 2 and 1 h at 60,90 and 125 ℃respectively, post-treatment process for the next lh at 180 ℃.

关 键 词：RTM 黏度 固化性能 

分 类 号：TB484.3[一般工业技术—包装工程]