高浓度充填料浆流变特性及其管道输送模拟优化研究  

Research on the Rheological Characteristics of High-concentration Filling Slurry and the Simulation and Optimization on Its Pipeline Transportation

作　　者：张亮[1,2] 罗涛[1,2] 许杨东 陈忠熙 刘杰[1,2] 

机构地区：[1]江西理工大学资源与环境工程学院,江西赣州市341000 [2]江西理工大学江西省矿业工程重点实验室,江西赣州市341000

出　　处：《矿业研究与开发》2016年第4期36-41,共6页Mining Research and Development

基　　金：江西省科技支撑计划项目(20141BBG70097);江西省研究生创新专项资金项目资助(YC2014-S350)

摘　　要：针对矿山充填系统设计中物料的合理配比、管道参数等难以确定的问题,采用软固体测试仪,通过试验得到不同组别高浓度充填料浆的剪切速率-剪切应力流变曲线图,进而求得料浆相应粘度系数η和屈服应力τ0,再采用ANSYS软件对料浆在管道中的流动进行数值模拟分析,结果表明,物料质量浓度为72%、管内径D2=150 mm的输送条件能保证料浆管流输送中沿程最大流速、出口处最大流速和入口处压力值均较小,矿山据此进行充填系统的设计与运行。It is difficult to determine the reasonable material proportions and pipeline parameters in the design of mine filling system. According to these problems,the soft-solid tester was used to obtain shear rate-shear stress rheological curve of different groups of slurry by experiment,then the viscosity coefficient and yield stress of slurry were gained. Furthermore,ANSYS software was applied to simulate the slurry pipeline flow. The results showed that the optimal condition was transmission parameter of material concentration 72% and pipe diameter D2= 150 mm. Thus,the maximum speed in pipeline,the maximum velocity at the outlet and the pressure value at the inlet of slurry were all smaller enough in its pipeline,which was the foundation for the design and operation of filling system.

关 键 词：高浓度充填 流变特性 黏度系数 管道输送 数值模拟 

分 类 号：TD853.34[矿业工程—金属矿开采]