多绳缠绕提升系统的虚拟样机建模方法研究  

Research on modeling method of virtual prototype of multi-rope winding hoisting system

作　　者：杨芳[1] 马喜强[1] 薛玉君[2] 邹声勇 程克强[2] 

机构地区：[1]河南科技大学河南省机械设计及传动系统重点实验室,河南洛阳471003 [2]河南科技大学机电工程学院,河南洛阳471003 [3]矿山重型装备国家重点实验室,河南洛阳471039

出　　处：《矿山机械》2016年第7期31-35,共5页Mining & Processing Equipment

基　　金：国家973计划课题资助项目(2014CB049401);河南省基础与前沿技术研究计划资助项目(132300410001);河南省高校科技创新团队支持计划资助项目(15IRTSTHN008)

摘　　要：针对多绳缠绕式矿井提升系统开展了基于Recur Dyn的虚拟样机建模方法研究。提出提升系统的模型简化条件;基于CATIA构建了主轴装置、提升容器及罐笼的三维实体模型,并在Recur Dyn中进行动力学约束添加;基于轴套力模型理论,将钢丝绳离散成有限段、连续的刚性圆柱体,并通过设置六分量的场力模拟钢丝绳的拉、压、弯、扭等力学性能;建立了多绳缠绕提升系统虚拟样机的约束条件,通过理论计算及经验公式确定了约束参数;所建立的多绳缠绕提升系统的虚拟样机,为开展超深矿井提升系统的动力学性能分析以及设计参数验证提供了可靠的仿真模型。The modeling method of virtual prototype of the multi-rope winding hoisting system based on Recur Dyn was researched. The simplification conditions of the hoisting system were proposed; CATIA was applied to build 3D solid model of the spindle assembly, lifting container and cage, and dynamics restraints were added in Recur Dyn; based on mechanical model and theory of bushing, the wire rope was converted to finite segment and continuous rigid cylinder, and six components of the field force were set to simulate the mechanical performance of the wire rope such as tension, compression, bending, torsion and so on; the restraint conditions of virtual prototype of the multi-rope winding hoisting system were established, and theoretical calculation and empirical formula were applied to determine the restraint parameters. The established virtual prototype of the multi-rope winding hoisting system offered reliable simulation model for dynamics performance analysis of the hoisting system in ultra-deep shaft and verification of design parameters.

关 键 词：多绳缠绕提升系统 虚拟样机 RECUR Dyn 

分 类 号：TD534[矿业工程—矿山机电]