基于CAE/CAD的内侧抽芯注射模设计  

Design of Injection Mold with Inside Core-Pulling by CAE/CAD Technique

作　　者：赵会娟[1] 李秀副[1] 刘波[1] 任艳霞[1] 唐光胤[1] ZHAO Hui-juan LI Xiu-fu LIU Bo REN Yan-xia TANG Guang-yin(Department of Mechanical and Electrical Engineering, Jiyuan Vocational and Technical College ,Jiyuan ,459000, Hena)

机构地区：[1]济源职业技术学院机电工程系,河南济源459000

出　　处：《蚌埠学院学报》2016年第5期10-13,共4页Journal of Bengbu University

摘　　要：以某盒盖塑件为例介绍了CAE分析与3D CAD设计相结合的模具设计方法。在MOLDFLOW中创建模型,根据相关分析结果选定了浇口位置和初始成型工艺参数;对拟定的初始浇注系统方案进行了充填分析,优化了浇口尺寸并在模具内增设了冷却回路,经冷却+流动+翘曲分析验证,优化后的方案能够生产出合格塑件;根据优化方案在CREO2.0中进行了3D CAD模具设计,针对该类抽芯力和抽芯距不大但需从四个方向抽芯的小型塑件,选择了斜导杆导滑内侧抽芯机构。上述过程表明,这种CAE与CAD相结合的设计方法可大幅缩短模具设计和试模周期,提高设计效率,减少资源浪费,同时也为同类塑件的模具设计提供了参考。The design method combining CAE analysis and 3D CAD with mold design was introduced by taking some box lid as an example in the paper. CAE model was built with MOLDFLOW,gate location was selected and initial molding process parameters were assigned according to related simulation result. Fill simulation was performed on scheme of initial casting system,consequently gate size was optimized and several cooling circuits were added in the mold. Subsequently the optimized scheme was verified to be able to produce qualified plastic parts,CAE results provided basis for selection of injection molding machine. According to optimized scheme,3D CAD mold design was completed with CREO2. 0. In view of the core pulling force and distance being very small but needing pulling from 4 directions,the inside core pulling mechanism with inclined guide rod was selected. Above process showed that combination of CAE and CAD design method can significantly shorten the mold design and mold test cycle,improve design efficiency,reduce waste of resources,and also provide reference for mold design of similar plastic parts.

关 键 词：CAE分析 CAD注射模设计 内侧抽芯机构 斜导杆 

分 类 号：TQ320.66[化学工程—合成树脂塑料工业]