检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:牛改改 游刚[1,2,3] 张晨晓[1,2,3] 余振宁[1]
机构地区:[1]钦州学院食品工程学院,广西钦州535000 [2]广西北部湾海洋生物多样性养护重点实验室/北部湾海洋生物资源开发与保护重点实验室,广西钦州535000 [3]广西北部湾特色海产品资源开发与高值化利用高校重点实验室,广西钦州535000
出 处:《南方农业学报》2016年第6期994-1000,共7页Journal of Southern Agriculture
基 金:广西北部湾海洋生物多样性养护重点实验室项目(2015ZC09);北部湾海洋生物资源开发与保护重点实验室项目(2015ZC15)
摘 要:【目的】优化近江牡蛎多糖提取工艺,为不同海域牡蛎多糖含量对比及其结构分析打下基础。【方法】以近江牡蛎为原料,通过单因素试验考察液料比、提取温度、提取时间、提取次数4个因素对其多糖提取率的影响,并在此基础上选取液料比、提取时间及提取温度3个因素为变量,近江牡蛎多糖提取率为考察指标,采用Box-Behnken试验设计方法建立回归模型,以优化近江牡蛎多糖提取工艺条件。【结果】通过响应面法建立近江牡蛎多糖提取率(Y)与液料比(A)、提取时间(B)、提取温度(C)的二次多项式数学模型为:Y=9.65-0.18A-0.071B+0.080C-0.27AB-0.24AC-0.52BC-2.6A2-1.34B2-1.35C2,该模型拟合度好;最佳提取工艺条件为:液料比90∶1、提取温度90℃、提取时间3 h、提取次数1次,在此条件下的近江牡蛎多糖提取率为9.72%,与预测值(9.66%)相对偏差为0.62%。【结论】采用响应面分析法优化近江牡蛎多糖提取工艺具有可行性,可用于实际生产,以提高多糖提取率。[Objective]The present experiment was conducted to optimize the extraction process of polysaccharide from Ostrea rivularis Gould, in order to provide a theoretical basis for comparing and analyzing content and structure of oyster polysaecharide in different sea areas. [Method]The effects of liquid-solid ratio, extraction temperature, extraction time and extraction times on extraction rate of polysaccharides from O. rivularis were investigated by single-factor test. Mean- while, based on the results of single-factor test, liquid-solid ratio, extraction time and extraction temperature was chosen as independent variables, and the extraction rate of oyster polysaccharide was selected as response value. Then the regres- sion model was established by Box-Behnken experiment design method, so as to optimize extraction process of polysaccha- ride from O. rivular/s. [Result]The mathematical model for quadratic polynomial of polysaccharide extraction rate (Y) with liquid-solid ratio (A), extraction time (B), extraction temperature (C) was established by response surface method, as fol- low: Y=9.65-0.18A-0.071B+0.080C-0.27AB-0.24AC-0.52BC-2.6A2-1.34B2-1.35C2, with high fitting degree. The opti- mum conditions of extraction process were as follows: 90:1 of liquid-solid ratio, 90℃ of extraction temperature, 3 h of ex- traction time, extracting 1 time. Under the above optimum conditions, the extraction rate of polysaccharide from O. rivularis reached up to 9.72%, which was close to the predicted value(9.66%), with relative deviation of 0.62%. [Conclusion]The response surface methodology is a workable method to optimize extraction conditions of polysaecharide from O. rivularis, which should be applied to increase effectively extraction rate of polysaceharides in actual production.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222