珠光体钢丝冷变形加工硬化行为研究  

Study on Work Hardening Behavior of Cold Deformation of Pearlite Steel Wires

作　　者：姚利丽[1,2] 底华芳 王威[1,2] 朱晨露[1,2] 周洁[1,2] 倪自飞[1,2] 

机构地区：[1]江苏兴达钢帘线股份有限公司,江苏泰州225721 [2]江苏省结构与功能金属复合材料重点试验室,江苏泰州225721

出　　处：《热加工工艺》2017年第1期69-73,共5页Hot Working Technology

基　　金：江苏省自然科学基金青年基金项目(BK20140584);江苏省博士后科研资助计划(1401075C)

摘　　要：采用不同含碳量的热处理后镀铜钢丝,主要研究了珠光体钢丝在冷拉拔变形过程中的抗拉强度与真应变的关系,并探讨了珠光体钢丝的加工硬化行为。结果表明:当真应变小于2.12时,钢丝的抗拉强度随着真应变的增加呈线性增加趋势。珠光体钢丝的加工硬化过程分为三个阶段:真应变ε<1.5时,材料加工硬化率随真应变的增加而下降,加工硬化指数较低;1.5≤ε≤4.0时,加工硬化率随真应变的增加而增加,加工硬化指数快速升高;真应变ε>4.0后,加工硬化率急剧下降,加工硬化指数呈抛物线下降。The relationship between tensile strength and true strain of pearlite steel wires in the process of cold drawing deformation was mainly studied using copper coated steel wire with different carbon contents after heat treatment. And the work hardening behavior was discussed. The results show that when the true strain is less than 2.12,the tensile strength of the steel wire increases linearly with the increase of the true strain. The work hardening process ofpearlite steel wires are divided into three stages： when the true strain is ε 〈 1.5, the work hardening rate decreases with the increase of true strain, and the work hardening exponent is lower; when the true strain is 1.5 ≤ε ≤ 4.0, the work hardening rate increases with the increase of true strain, and the work hardening exponent increased rapidly; when the true strain is ε 〉4.0, the work hardening rate decreases sharply and the work hardening exponent decreases exponentially.

关 键 词：珠光体钢丝 抗拉强度 真应变 加工硬化率 加工硬化指数 

分 类 号：TG301[金属学及工艺—金属压力加工]