8～14μm波段低发射率涂层材料的制备及性能研究  

Preparation and Properties of Low-emissivity Coatings in 8～14 μm Band

作　　者：陶睿[1] 刘朝辉[1] 班国东 叶圣天 杨宏波[1] 罗平[1] 舒心[1] 

机构地区：[1]后勤工程学院化学与材料工程系 [2]中国人民解放军75752部队 [3]中国人民解放军63983部队

出　　处：《表面技术》2017年第10期207-212,共6页Surface Technology

基　　金：全军后勤科研计划项目(BY115C007)~~

摘　　要：目的为满足市场对低发射率涂层的需要,制备了低发射率涂层材料,并讨论填料和基体树脂对其红外发射率的影响。方法以325、500、800、1000、1200、1500目铝粉为填料,丙烯酸树脂(AR)、环氧树脂(ER)和聚氨酯树脂(PR)为基体树脂,制备了低发射率涂层,分别从基体树脂种类、黏度、铝粉粒径及含量四个方面对涂层红外发射率进行了研究。结果 PR涂层在8~14μm波段的红外发射率最低,PR为低发射率涂层用基体树脂的最佳选择。涂层红外发射率随着基体树脂黏度的增大逐渐降低,并且变化趋势接近于线性。在研究范围内,铝粉的最佳粒径为325目,且涂层红外发射率随铝粉含量的增加而降低。结论制备的低发射率涂层的红外发射率低,而且环保。The work aims to meet market demand of low-emissivity coatings by preparing low-emissivity coatings and discussing effects of filler and matrix resin on infrared emissivity. The low-emissivity coatings were prepared with A1 powder （325 meshes, 500 meshes, 800 meshes, 1000 meshes, 1200 meshes, 1500 meshes） as filler, and acrylic resin （AR）, epoxy resin （ER） and polyurethane resin （PR） as matrix resin. The infrared emissivity was studied in terms of matrix resin type and viscosity, Al powder particle size and content. The PR coating exhibited the lowest infrared emissivity in 8~14 μm band, hence it was the best choice for low emissivity coatings. The infrared emissivity of coatings gradually decreased as matrix resin viscosity in- creased, and variation trend was approximately linear. Optimal particle size of Al powder within the research scope was 325 meshes, and the infrared emissivity of coatings decreased as the content of Al powder increased. The low-emissivity coatings prepared exhibits low infrared emissivity, which is environmentally friendly.

关 键 词：低发射率涂层 红外发射率 金属填料 吸光度系数 黏度 Stokes定律 

分 类 号：TU561.6[建筑科学—建筑技术科学]