检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:赵杰鸽 王星星 王焕 白洁 孙海龙 ZHAO Jiege;WANG Xingxing;WANG Huan;BAI Jie;SUN Hailong(Luoyang Mining Machinery Engineering Design Institute Co.,Ltd.,Luoyang 471039,Henan,China;State Key Laboratory of Mining Heavy Equipment,Luoyang 471039,Henan,China;CITIC Heavy Industries Co.,Ltd.,Luoyang 471039,Henan,China)
机构地区:[1]洛阳矿山机械工程设计研究院有限责任公司,河南洛阳471039 [2]矿山重型装备国家重点实验室,河南洛阳471039 [3]中信重工机械股份有限公司,河南洛阳471039
出 处:《矿山机械》2018年第8期36-41,共6页Mining & Processing Equipment
摘 要:针对φ12.2 m×8.8 m半自磨机法兰连接螺栓在自身质量、钢衬板质量、电动机转子质量、电动机磁拉力、物料载荷和螺栓预紧力载荷下,采用有限元方法进行建模分析。并基于BS 7608—2014标准,对中空轴和端盖连接螺栓、端盖和筒体连接螺栓、进料端筒体和出料端筒体连接螺栓进行疲劳评估。在满足安全和使用性能的前提下,对比分析后,选择最佳的螺栓规格及数量。The flange connection bolts of SAG mill φ 12.2 m×8.8 m under the action of the mill gravity, the liner gravity, motor rotor gravity, motor magnetic pull, charge load and bolt pretightening force was modeled and analyzed by using FEA method. In addition, based on standard BS 7608—2014, the fatigue evaluation on the connection bolts of trunnion and end cover, the connection bolts of end cover and shell and the connection bolts of feeding shell and discharging shell was conducted. On the premise of satisfying the safety and service performance, optimal size and number of the bolts were identified after comparison and analysis.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.200