油脂含量常用检测方法分析及优化  

Analysis and Optimization of Determination Method of Oil Content

作　　者：宋柯峥 余枭 谢晓航 叶萌 宋慧婷[1] SONG Ke-zheng;YU Xiao;XIE Xiao-hang;YE Meng;SONG Hui-ting(School of Resource and Environmental Science of Hubei University,Hubei Wuhan 430062,China)

机构地区：[1]湖北大学资源环境学院,湖北武汉430062

出　　处：《广州化工》2018年第20期69-71,共3页GuangZhou Chemical Industry

基　　金：湖北省科技厅技术创新重大专项项目(2017ABA139);武汉市科技局应用基础研究计划(2017020201010229)

摘　　要：根据国标重量法(CJ/T57-1999)进行实验,无水硫酸钠未定量的情况下,用30～60℃沸程的石油醚做萃取剂,平均油脂回收率为83. 18%。实验发现,60～90℃沸程石油醚做萃取剂的回收率为76. 53%～81. 07%,低于国标法中30～60℃沸程的石油醚做萃取剂时的最低回收率,因此30～60℃沸程的石油醚更适用于油脂回收实验。用30～60℃沸程的石油醚实验,其中投加10 g无水硫酸钠,回收率最高。因此30～60℃沸程的石油醚做萃取剂并投加10 g无水硫酸钠,对于体积为300 m L,含油浓度为500 mg/L的调和油回收率最高且稳定。The national standard weight method （CJ/T57-1999 ） was optimized. By running experiments, the average oil recovery was 83.18% when following the standard weight method with 30~60 ℃ boiling range petroleum ether. And anhydrous sodium sulfate was not quantified. The 60~90 ℃ boiling range petroleum ether was used as the extractant instead in further research. With the recovery of 76.53%~81.07%, the result was lower than the minimum recovery of previous method with 30~60 ℃ boiling range petroleum ether, indicating that 30~60 ℃ boiling range petroleum ether was more suitable for oil recovery experiments. Different amounts of anhydrous sodium sulfate were added as the extractant with 30~60 ℃ boiling range petroleum. It was found that it reached the highest recovery rate when 10 g of anhydrous sodium sulfate was added. Therefore, for 300 mL blended oil with an oil concentration of 500 mg/L, using 30~60 ℃ boiling range of petroleum ether as an extractant and dosing 10 g of anhydrous sodium sulfate as dehydrating agent was the highest and most stable method.

关 键 词：含油废水 油脂含量 重量法 方法优化 

分 类 号：X832[环境科学与工程—环境工程]