检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:赵文[1] 陈阳[1] 李慎刚 唐志扬[2] 柏谦 张超哲[1] ZHAO Wen;CHEN Yang;LI Shengang;TANG Zhiyang;BAI Qian;ZHANG Chaozhe(School of Resourees & Civil Engineering,Northeastern University,Slwnyang,Liaoning 110819,China;Guangzhou Metro Design & Researeh Institute Co.,Ltd.,Guangzhou,Guangdong 510010,China)
机构地区:[1]东北大学资源与土木工程学院,辽宁沈阳110819 [2]广州地铁设计研究院有限公司,广东广州510010
出 处:《水利与建筑工程学报》2018年第5期12-17,共6页Journal of Water Resources and Architectural Engineering
基 金:国家自然科学基金项目(51578116)
摘 要:基于隧道开挖引起地表沉降经典Peck公式,考虑砂土地区浅埋非对称近接平行隧道不同开挖步序,研究隧道周围土体横向水平位移及工后地表沉降规律。根据沉降叠加原理,建立考虑隧道内径均匀收敛非对称近接平行隧道修正Peck公式,并进行影响因素讨论。结果表明:土体横向水平位移集中在横通道转正洞及大直径断面拱脚处;隧道施工后地表沉降主要发生在小断面区域;地表横向沉降模拟值与计算值二者吻合较好,随着隧道圆心距L的增大,土体横向沉降量逐渐减小并由正态分布转变为马鞍形;隧道埋深H越大,沉降越大;非对称隧道施工时先开挖小断面隧道优于先开挖大断面隧道。Ground settlement and horizontal displacement were analyzed based on FEM software of different excavation sequences. The modified peck equation was established considering even shrinkage of inner diameter based on superposition principle and different factors. The results showed that displacement was mainly distributed in small cross-section of two tunnels,horizontal displacement was mainly at arch bottom between horizontal passage and main tunnel. The simulation results of ground settlement and calculation results fit well,the displacement became smaller and transformed from normal distribution to saddle-shape with the enlargement of L,the larger settlement,the deeper bury depth H. Tunnel with smaller cross-section should be constructed earlier than large cross-section tunnel.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.3