偶联剂KH570对吸油树脂性能的影响  

Influence of coupling agent KH570 on properties of oil absorption resin

作　　者：李杨[1] 白琪俊 段攀峰[2] 伍玉娇[1,2] 刘学金[1] 赵行[1] Li Yang;Bai Qijun;Duan Panfeng;Wu Yujiao;Liu Xuejin;Zhao Hang(School of Materials Science and Metallurgy Engineering, Guizhou Institute of Technology, Guiyang 550003, China;Material and Metallurgy College of Guizhou University, Guiyang 550001, China)

机构地区：[1]贵州理工学院材料与冶金工程学院,贵州省贵阳市550003 [2]贵州大学材料与冶金学院,贵州省贵阳市550001

出　　处：《合成树脂及塑料》2017年第4期47-50,59,共5页China Synthetic Resin and Plastics

基　　金：贵州省科技厅贵州理工学院联合基金项目(黔科合LH字[2014]7371号)

摘　　要：采用悬浮聚合,以甲基丙烯酸甲酯、丙烯酸丁酯和苯乙烯为单体,过氧化苯甲酰(BPO)为引发剂,二乙烯苯(DVB)为交联剂,合成了吸油树脂。研究了单体配比,引发剂、交联剂用量对树脂吸油率的影响,在聚合过程中引入偶联剂KH570共聚合,分析了树脂的吸油性能和缓释行为。结果表明:当丙烯酸丁酯和甲基丙烯酸甲酯的质量比为2∶1,BPO和DVB用量分别为单体总质量的1.0%,0.5%时,树脂的综合吸油率最好;使用KH570的树脂开始分解温度和最大分解速率温度分别升高到383.9,406.9℃,树脂对机油的保油性得到明显的改善。Oil absorption resin was synthesized via suspension polymerization with methyl methacrylate(MMA),butyl acrylate(BA)and styrene as monomers,benzoyl peroxide(BPO)as the initiator,and divinylbenzene(DVB)as crosslinking agent.The effect of monomer ratio,the mass fraction of initiator and crosslinkingagent on the oil absorption rate of the resin were observed.The coupling agent KH570was introduced for thepolymerization,the oil absorption and slow release of the resin were analyzed.The results show that the highestoil absorption rate is obtained when the mass ratio of BA and MMA is2∶1,the mass fraction of BPO and DVBin monomers are1.0%and0.5%respectively.The oil-holding capacity of the resin to engine oil is improvedsignificantly because the initial decomposing temperature and maximum decomposition rate temperature of theresin with KH570reach383.9℃and406.9℃.

关 键 词：吸油树脂 偶联剂 悬浮聚合 吸油率 热稳定性 

分 类 号：TQ324.8[化学工程—合成树脂塑料工业]