检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:周勇 程建圣[2,3,4] 张占国 冀超辉 ZHOU Yong;CHENG Jiansheng;ZHANG Zhanguo;JI Chaohui(Nalional Energy Investment Refco Group Ltd., Beijing 100011, China;School of Energy Resources and Safely, Anhui Universily of Science and Technology, HHainan 232001, China;State Key Laboratory of Gas Disaster Monitoring and Emergency Technology,Chongqing 400037, China;China Coal Technology and Engineering Group Chongqing Research Institute, Chongqing 400037, China)
机构地区:[1]国家能源投资集团有限责任公司,北京100011 [2]安徽理工大学能源与安全学院,安徽淮南232001 [3]瓦斯灾害监控与应急技术国家重点实验室,重庆400037 [4]中煤科工集团重庆研究院有限公司,重庆400037
出 处:《煤矿安全》2019年第2期223-227,共5页Safety in Coal Mines
基 金:国家自然科学基金重点资助项目(50534080);国家重点基础研究发展计划(973计划)资助项目(2012CB724206)
摘 要:为研究正断层煤层开挖煤岩体力学的特性,通过建立正断层附近煤层开挖时煤岩体的力学模型,运用FLAC3D数值计算并理论分析了上下盘开挖时煤岩体的力学特性。结果表明:水平位移、水平应力对煤层开挖顶端岩体的影响较小,地应力引起的竖向位移和开挖顶端相当应力是造成冒顶和开挖顶端岩体塌落的主要因素,当煤层中存在正断层时,从上盘开挖引起开挖顶端的相当应力和竖向位移比从下盘开挖引起的小,开挖区与断层距离越近,开挖顶端相当应力和竖向位移越大,相同条件下从上盘开挖较从下盘开挖更安全。因此,在工程实际中应尽量避免从下盘对煤层进行开挖,从而减小安全隐患。In order to study mechanical characteristics of coal and rock mass in coal seam excavation of normal fault, through establishing the mechanical model of coal and rock mass excavation in the vicinity of the normal fault, using FLAC3 Dnumerical calculation, we theoretically analyzed the coal and rock mass mechanical properties during excavation of upper and lower plates.The results show that horizontal displacement and horizontal stress have little effect on the excavation of the top rock mass of the coal seam. The vertical displacement caused by the ground stress and the considerable stress at the excavation top are the main factors causing collapse of the roof and the top of the excavated rock mass. When there is a normal fault, the considerable stress and vertical displacement caused by excavation from the upper plate is smaller than that caused by excavation from the lower plate. The closer the excavation area is to the fault, the greater the corresponding stress and vertical displacement at the top of excavation is. Under the same conditions, it is safer to excavate from the upper plate than from the lower plate. Therefore, in the actual project, the excavation of the coal seam from the lower plate should be avoided as far as possible so as to reduce the potential safety hazards.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.136.19.165