XPS泡沫塑料产品模型表面加工平整度的研究  

Study on the Effect of XPS Foam Plastic Product Model Surface Processing Flatness

作　　者：林乙煌[1] 刘喜明[1] 丁铮[2] LIN Yihuang;LIU Ximing;DING Zheng(Longyan University,Longyan,Fujian 364000,China;Fujian Agriculture and Forestry University,Fuzhou,Fujian 350001,China)

机构地区：[1]龙岩学院,福建龙岩364000 [2]福建农林大学,福建福州350001

出　　处：《龙岩学院学报》2019年第5期71-74,共4页Journal of Longyan University

基　　金：福建省中青年教师教育科研项目(JAS180510)

摘　　要：以XPS泡沫塑料产品模型考察模型制作的工作电压、切割时间、板材厚度等因素对模型切割面的平整度的影响,采用3因素3水平正交试验对XPS塑料模型制作工艺进行优化。试验得出XPS塑料模型最佳平整度的工艺条件为切割机工作电压10V、切割时间10s、板材厚度60mm,其中对模型表面水波纹影响最显著的因素是工作电压,对模型表面热腐蚀影响最显著的是板材厚度。By taking the working voltage,cutting time and sheet thickness of XPS model as the single factor,and taking the smoothness of cutting surface as the index,the optimization level of each single factor was screened out by single factor test.Then,according to the single factor test results,the manufacturing process of XPS plastic model was optimized by three factors and three levels orthogonal test.The results show that the optimum flatness of XPS plastic model is working voltage 10V,cutting time 10s and cutting thickness 60mm.The most significant factor affecting water ripple of model surface is working voltage,and the most significant factor affecting hot corrosion of model surface is plate thickness.

关 键 词：XPS泡沫塑料 产品模型 表面质量 

分 类 号：TS951[轻工技术与工程]