检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:钱鼎玮 杨新文[1,2] 刘晓波 马晓云[1,2] Qian Dingwei;Yang Xinwen;Liu Xiaobo;Ma Xiaoyun(Shanghai Key Laboratory of Rail Infrastructure Durability and System Safety,Tongji University,Shanghai 201804,China;Key Laboratory of Road and Traific Engineering,Ministry of Education,Tongji University,Shanghai 201804,China;State Key Laboratory of Heavy Duty AC Drive Electric Locomotive Systems Integration,Zhuzhou 412000,China)
机构地区:[1]同济大学上海市轨道交通结构耐久与系统安全重点实验室,上海201804 [2]同济大学道路与交通工程教育部重点实验室,上海201804 [3]大功率交流传动电力机车系统集成国家重点实验室,株洲412000
出 处:《动力学与控制学报》2020年第3期44-50,共7页Journal of Dynamics and Control
基 金:国家自然科学基金资助项目(51778484);大功率交流传动电力机车系统集成国家重点实验室开放课题(2017ZJKF08)。
摘 要:采用模态叠加法求得阻尼车轮导纳特性,利用已建立的轮轨滚动噪声预测模型,以轮轨表面粗糙度为激励,分析了辐板阻尼层与其厚度对阻尼车轮振动与声辐射特性的影响规律.首先,建立了阻尼车轮三维实体有限元模型,采用Block Lanczos方法计算车轮模态特征;其次,利用模态叠加法求得车轮在单位荷载激励下的频响函数;然后,利用虚拟激励法求得车轮在粗糙度谱激励下的频域振动特性;最后,依据车轮动态响应通过解析的方法求得车轮声辐射频域特性.计算结果表明:(1)车轮辐板敷设阻尼层对车轮1000Hz以下频率的振动与噪声的抑制作用不明显,而对车轮1600Hz以上的高频振动具有良好的抑制作用;(2)车轮辐板双侧敷设阻尼的降噪效果优于单侧阻尼;(3)阻尼层可以有效抑制车轮振动,且车轮辐板敷设阻尼层厚度越厚效果越明显.The modal superposition method was used to obtain the admittance characteristics of damped wheels.Based on the established prediction model of wheel/rail rolling noise and taking the surface roughness of wheels and rails as the excitation,the influence of the position and thickness of a damping layer on vibration and sound radiation characteristics of damped wheels was analyzed.Firstly,a three-dimensional solid finite element model of damped wheels was established,and the Block Lanczos method was used to calculate the modal characteristics of wheels.Secondly,the frequency response function of wheels under unit load was obtained by the modal superposition method.Then,the frequency domain vibration characteristics of wheels under the excitation of roughness spectrum were obtained by the virtual excitation method.Finally,the frequency domain characteristics of acoustic radiation were obtained by an analytic method based on the dynamic responses.The results showed that the damping layer laid on the wheel web has no obvious effect on vibration and noise suppressions of the wheel below 1000 Hz,but performs good function above 1600 Hz.The noise reduction by the damping layer laid on both sides of the web of the wheel is better than that by the damping layer only laid on one side.The thicker the thickness of the damping layer is,the more obvious the noise reduction is.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222