检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:张茉颜 肖宏[1] ZHANG Moyan;XIAO Hong(Beijing Key Lab of Track Engineering,Beijing Jiaotong University,Beijing 100044,China)
机构地区:[1]北京交通大学轨道工程北京市重点实验室,北京100044
出 处:《西南交通大学学报》2020年第5期1094-1102,共9页Journal of Southwest Jiaotong University
基 金:中央高校基本科研业务费专项资金(2019YJS138)。
摘 要:为研究强横风条件下轨道结构的力学特性,采用计算流体力学和有限元联合仿真,对轨道结构的受力和变形进行了分析.首先采用SOLIDWORKS软件基于CRH380A型高速列车实际外形轮廓建模,然后通过FLUENT计算得到列车的气动特性,再与有限元软件ABAQUS联合仿真建立列车-轨道耦合模型;模型中完整地保留列车表面所受的气动力,解决了流固耦合中列车气动力的传递问题;最后基于建立的耦合模型,针对强横风作用下轨道结构的力学特性进行系统分析.研究结果表明,当列车运行速度为350 km/h,风速从0变化到15 m/s时,钢轨背风侧处横向位移从0.177 mm增加到2.100 mm,增大了11.86倍,可见强横风条件下,要重点关注钢轨背风侧处横向力学特性;当风速超过15 m/s时,列车运行速度达到250 km/h,钢轨横向位移超出了最大允许值2.000 mm,表明长期的强横风作用将会导致轨道的几何形位发生改变,但此时轮重减载率和脱轨系数并未超出对应限值0.65和0.800.因此,横风作用下不仅要考虑列车运行安全性指标,也要考虑轨道结构力学指标的变化.In order to explore the mechanical characteristics of track structure under strong cross wind,the cosimulation of CFD and FEM is used to analyze the force and deformation of track structure.Firstly,SOLIDWORKS is used to establish a model based on the CRH380A high-speed train.Then,the aerodynamic characteristics of the train are calculated by FLUENT and the train-track coupling model is established by finite element software ABAQUS.The aerodynamic force on the surface of the train is completely retained in the model,which has solved the problem of aerodynamic force transfer in the fluid-solid coupling.Finally,based on the established coupling model,the mechanical characteristics of the track structure under strong cross wind are analyzed.The results show that when the train running speed is up to 350 km/h and the wind speed changes from 0 to 15 m/s,the lateral displacement on the leeward side of the rail increases from 0.177 mm to 2.100 mm,which increases by 11.86 times.This indicates that the mechanics of the rail leeward side should be focused.When the wind speed exceeds 15 m/s and the train operation speed is 250 km/h,the rail lateral displacement is beyond the allowable maximum of 2.000 mm,showing that long-term cross wind will lead to track geometry change.However,the rate of wheel load reduction and the coefficient of derailment is not up to the limit of 0.65 and 0.800,respectively.Therefore,it is necessary to consider not only the safety index of train operation,but also the change in the mechanical characteristics of track structure.
关 键 词:联合仿真 计算流体力学 有限元方法 强风条件 轨道结构
分 类 号:U216.4[交通运输工程—道路与铁道工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.13