钛含量对钼钛合金组织及力学性能的影响  

Effects of Ti content on microstructure and mechanical properties of Mo-Ti alloys

作　　者：牛炫阳 张鹏飞[1] 王广欣[1] NIU Xuanyang;ZHANG Pengfei;WANG Guangxin(School of Materials Science and Engineering,Henan University of Science and Technology,Luoyang 471023,China)

机构地区：[1]河南科技大学材料科学与工程学院,河南洛阳471023

出　　处：《粉末冶金工业》2020年第6期45-49,共5页Powder Metallurgy Industry

基　　金：国家科技重大专项(02专项)(2017ZX02408003)。

摘　　要：以高纯钛粉和钼粉为原料,在1 600℃温度和40 MPa的压力以及氩气保护下热压3 h,制备了5种不同成分的钼钛合金。研究了钛含量对钼钛合金力学性能和显微组织的影响。结果表明,Mo原子和Ti原子能够形成置换固溶体,且Mo-Ti合金在常温下具有脆性特征。随着钛原子分数从10%增加到50%,晶粒尺寸从7μm增加到15μm,致密度从95.8%提升至99.5%,洛氏硬度从22.3HRC增加到45.5HRC,抗弯强度从396 MPa增加到680 MPa。Mo-50%Ti(原子分数)的各方面性能最佳,这对后续钼钛合金靶材的制备及溅射性能研究具有一定意义。Five kinds of Mo-Ti alloys with different composition were prepared with high purity titanium powder and molybdenum powder by hot pressing at 1 600 ℃ and 40 MPa for 3 h under the protection of Argon. Effects of titanium content on mechanical property and microstructure of the prepared Mo-Ti alloys were studied. Results obtained show that Mo and Ti atoms can form displacement solid solution,and Mo-Ti alloy is brittle at room temperature. With titanium content increasing from 10 atm.% to 50 atm.%,grain size increases from about 7 μm to 15 μm,relative density increases from 95.8% to 99.5%,rockwell hardness increases from 22.3 HRC to 45.5 HRC,and bending strength increases from 396 MPa to 680 MPa. Mo-50% Ti has the best performance in all aspects,which has a certain significance for the preparation of Mo-Ti alloy target and the study of sputtering performance.

关 键 词：粉末冶金 热压 钼钛合金 

分 类 号：TF125.2[冶金工程—粉末冶金]