检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:付国志 韦金城 赵延庆[3] 李强 FU Guozhi;WEI Jincheng;ZHAO Yanqing;LI Qiang(School of Civil Engineering, Dalian University of Technology, Dalian 116024, Liaoning, China;Key Laboratory for Expressway Maintenance Technology Ministry of Transport, Shandong Transportation Research Institute, Jinan 250031,Shandong, China;School of Transportation and Logistics, Dalian University of Technology, Dalian 116024, Liaoning,China;Dongmeng Engineering Co., Ltd, Second Highway Engineering Co., Ltd,China Communications Construction Company, Xi'an 710119, Shaanxi, China)
机构地区:[1]大连理工大学土木工程学院,辽宁大连116024 [2]山东省交通科学研究院高速公路养护技术交通行业重点实验室,山东济南250031 [3]大连理工大学交通运输学院,辽宁大连116024 [4]中交二公局东萌工程有限公司,陕西西安710119
出 处:《华南理工大学学报(自然科学版)》2021年第4期90-96,共7页Journal of South China University of Technology(Natural Science Edition)
基 金:国家自然科学基金资助项目(51678114);乌鲁木齐市建设科技项目(JSKJ201806)。
摘 要:采用谱单元法计算了典型沥青路面结构的动态弯沉,并与层状弹性体系理论所得的静态弯沉进行了对比;针对5种实际工程路段,分别按动、静态方法和2017版规范方法计算验收弯沉值,并与实测弯沉进行对比分析。结果表明:FWD荷载作用下,路面结构的静态弯沉均大于动态弯沉,沥青层厚度越大、土基模量越小、距荷载中心距离越远,二者相差越大,动态效应越显著;忽略FWD荷载引起的动态效应会导致验收弯沉值偏大,2017版规范所得的静态验收弯沉值可为实测弯沉的近4倍,这在一定程度上放宽了验收标准;动态方法所得弯沉仅为实测弯沉的1.5倍左右,采用动态方法对沥青路面结构进行验收,更能有效控制路面施工质量;2017版规范中用于协调理论弯沉和实测弯沉差异的土基模量调整系数并未起到有效作用,反而加大了二者的差异,其合理性还有待商榷。The dynamic deflection was calculated with the spectral element method,and the results were compared with the static deflection that was obtained from the layered elastic theory.The acceptance deflections of 5 engineering sections were computed using dynamic,static methods and the specification method of JTG D50—2017,respectively,and the results were compared with the field measured deflections.The results show that under the effect of falling weight deflectometer(FWD)load,the static deflections of pavement structures are greater than the dynamic deflections;the gap between the dynamic and static deflections increases with the increase of asphalt layer thickness,the decrease of subgrade modulus and the increase of distances between the sensors and the loading center,and asphalt pavements'dynamic effects are more obvious.The ignorance of the effects of FWD load will lead to a larger acceptance deflection.The static acceptance deflection can be nearly 4 times of the measured deflection,which extends the acceptance criteria to a certain extent.While the dynamic deflection is only about 1.5 times of the measured deflection,and the dynamic method can more effectively control the pavement construction quality.The adjustment coefficient of the subgrade modulus in JTG D50—2017 unexpectedly increases the differences between the theoretical and measured deflections,so its validity remains to be discussed.
分 类 号:U416.01[交通运输工程—道路与铁道工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.229