检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李国强[1] 王琛奥 王志鲁 叶丰[2] 陈素文[1] LI Guoqiang;WANG Chen'ao;WANG Zhilu;YE Feng;CHEN Suwen(Department of Structural Engineering,Tongji University Shanghai,200092,China;National Maglev Transportation Engineering R&D Center,Tongji University Shanghai,201804,China)
机构地区:[1]同济大学土木工程学院,上海200092 [2]同济大学国家磁浮交通工程技术研究中心,上海201804
出 处:《振动.测试与诊断》2021年第5期847-854,1028,共9页Journal of Vibration,Measurement & Diagnosis
基 金:“十三五”国家重点研发计划先进轨道交通重点专项资助项目(2016YFB1200601)。
摘 要:磁浮轨道梁日照作用下的温度变形是轨道梁静力与动力设计需考虑的重要因素,笔者根据传热学与有限元理论,结合夏季气象参数与日照辐射半经验公式,利用ANSYS建立磁浮线轨道钢箱梁日照温度场三维瞬态模型。首先,分析磁浮轨道梁的最大竖向与横向温差发生时刻的温度梯度分布,基于日照温度场分析结果,计算不同支承形式钢轨道梁的温度变形;然后,将单跨简支、双跨连续形式轨道梁的温度变形作为初始不平顺组成部分,进行车桥耦合动力响应分析。结果显示:温度效应使车体加速度、悬浮气隙幅值增幅较大,对电磁力有所增大,对轨道梁加速度及位移的放大作用则不明显,各动力响应值仍处于规范规定的安全范围内,但安全度有所降低。The temperature deformation caused by solar radiation of the maglev track beam is an important factor to be considered in the static and dynamic design. Based on meteorological data and solar radiation semi-empirical formulas of Shanghai in summer,a three-dimensional model for a section of maglev line steel box girder with transient state analysis method has been established using ANSYS software. The temperature field is calculated according to the principle of heat conduction and finite element method. The temperature gradient distribution of the maximum vertical and lateral temperature difference of the maglev track beam is analyzed. Based on the analysis results of the sunshine temperature field,the temperature deformation of the steel track beam with different support forms is calculated. The temperature deformation of the single-span simply supported and double-span continuous form maglev track beam are taken as the initial irregularity components. Vehicle-bridge coupled dynamic analysis of the vehicle is carried out and the dynamic response is taken for analysis. Results show that the temperature effect obviously increases the acceleration of the vehicle body and the amplitude of the suspended air gap. The electromagnetic force is increased by thermal effect to a limited extent. The influence of thermal effect on acceleration and displacement for the track beam is not obvious. The dynamic response values are still within the safe range of the standard regulations,but the safety status is worse.
分 类 号:U237[交通运输工程—道路与铁道工程] TH113[机械工程—机械设计及理论]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.171