基于单一气源的PECVD方法制备SiC薄膜及其微观结构研究  

Fabrication and Microstructure Study of SiC Thin Film by PECVD Based on Single-source Gas

作　　者：李子曦 黄景林[1] 谢春平 邓承付 易泰民[1] 易勇[2] 杜凯[1] LI Zixi;HUANG Jinglin;XIE Chunping;DENG Chengfu;YI Taimin;YI Yong;DU Kai(Research Center of Laser Fusion,China Academy of Engineering Physics,Mianyang 621900,China;School of Materials Science and Engineering,Southwest University of Science and Technology,Mianyang 621010,China)

机构地区：[1]中国工程物理研究院激光聚变研究中心,四川绵阳621900 [2]西南科技大学材料科学与工程学院,四川绵阳621010

出　　处：《原子能科学技术》2022年第7期1473-1482,共10页Atomic Energy Science and Technology

基　　金：中国工程物理研究院激光聚变研究中心青年人才基金(RCFCZ3-2019-9)。

摘　　要：为制备出满足惯性约束聚变(ICF)实验要求的SiC薄膜,本文采用等离子体增强化学气相沉积(PECVD)法,以四甲基硅(TMS)作为唯一反应气源,在不同工作压强下制备SiC薄膜。利用扫描电子显微镜、表面轮廓仪、原子力显微镜、精密电子天平、X射线光电子能谱、傅里叶变换红外光谱对薄膜进行表征与分析。结果表明:SiC薄膜的成分与工作压强密切相关,随着工作压强的增加,薄膜中Si含量整体呈下降趋势;随着工作压强的增加,薄膜沉积速率先增大后减少,密度先减小后增大;与其他制备工艺相比,采用单一气源制备SiC薄膜,其表面粗糙度极低(1.25~1.85 nm),薄膜粗糙度随工作压强的增加呈先增大后减小的趋势。In recent years,silicon carbide(SiC)thin films are regarded as very important target materials in laser inertial confinement fusion(ICF)physical experiments due to their excellent physical and chemical properties.In order to meet the requirements of ICF physical experiment,many harsh conditions were put forward for SiC thin films,such as good surface morphology,low roughness,high density and fast deposition rate.Up to now,in order to study and improve the structure and properties of SiC thin films,a lot of researches were carried out by using different preparation processes.Among them,the preparation method of SiC thin films grown by single-source gas has the advantages of safety,reliability,simplicity and convenience,and avoiding the introduction of unnecessary impurities.Therefore,in order to reduce experimental errors and improve film quality,a single-source gas with stable chemical properties can be used to grow SiC thin films.In addition,the plasma enhanced chemical vapor deposition(PECVD)can be used to deposit crystalline or amorphous SiC thin films at lower temperature,with higher deposition rate and lower internal stress.The PECVD method based on a single-source gas was expected to produce SiC thin films that meet the requirements of ICF experiment,but few related studies were reported.In this work,SiC thin films used for ICF physical experiments were deposited on single-side polished n-type silicon(100)wafer by PECVD method with using the tetramethylsilane(TMS)as the single precursor gas and hydrogen(H 2)as the carrier gas with different working pressures.The surface morphology,microstructure,surface roughness,mass density,deposition rate,chemical elemental composition and bonding state of SiC thin films were mainly analyzed by scanning electron microscopy(SEM),atomic force microscopy(AFM),precision electronic balance,surface profilometer,X-ray photoelectron spectroscopy(XPS)and Fourier transform infrared spectroscopy(FT-IR),respectively.In the condition that deposition parameters keep unchanged,the infl

关 键 词：单一气源 SIC薄膜 工作压强 等离子体增强化学气相沉积法 

分 类 号：O469[理学—凝聚态物理]