检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:王丹杨 刘增瑞 李璇 丁鹏 谢娜 王路明[4] WANG Danyang;LIU Zengrui;LI Xuan;DING Peng;XIE Na;WANG Luming(Department of Prosthodontics,School of Stomatology,Xi’an Medical University,Xi’an 710021,China;School Hospital(Community Health Service Center of Weiyang Lake Medical College,Weiyang District),Xi’an Medical University,Xi’an 710021,China;Department of Oral Medicine,School of Stomatology,Xi’an Medical University,Xi’an 710021,China;Department of Stomatology,the Second Affiliated Hospital,Xi’an Medical University,Xi’an 710038,China)
机构地区:[1]西安医学院口腔医学院口腔修复学教研室,陕西西安710021 [2]西安医学院校医院未央区(未央湖医学院社区卫生服务中心),陕西西安710021 [3]西安医学院口腔医学院口腔内科学教研室,陕西西安710021 [4]西安医学院附属第二医院口腔科,陕西西安710038
出 处:《口腔疾病防治》2023年第1期23-27,共5页Journal of Prevention and Treatment for Stomatological Diseases
基 金:国家自然科学基金青年项目(81701014);国家级大学生创新创业训练计划项目(202011840006);陕西省大学生创新创业训练计划项目(S202011840006);西安医学院大学生创新创业训练计划项目(121520006)。
摘 要:目的探讨氩气源低温常压等离子体(nonthermal argonatmos phericpressure plasma,NTAPP)射流处理不同时间对牙本质⁃自酸蚀粘接剂粘接界面粘接强度及牙本质润湿性的影响。方法使用NTAPP发生装置(放电输入功率:9 W,氩气气体流量:5 L/min),分别处理5组(n=6)人牙本质试件(0、5、10、15、20 s)后,使用S3 Bond粘接剂处理牙面,制作微拉伸粘接试件并测量各组即刻粘接强度。同样参数、同样分组条件下处理牙本质面后测量牙本质表面接触角。结果随着NTAPP处理时间延长,牙本质即刻粘接强度呈显著上升趋势,以处理15 s组粘接强度最高(31.82±2.80)MPa。随着NTAPP处理时间延长,与阴性对照组牙本质表面接触角(75.57°±1.45°)相比,各实验组牙本质表面接触角均显著减小,以处理15 s组牙本质表面接触角(33.56°±2.14°)最低,湿润性最大。结论NTAPP处理可显著增加牙本质表面湿润性,提高与自酸蚀粘接剂粘接界面的粘接强度,这与处理时间相关。Objective To study the effect of nonthermal argon atmospheric pressure plasma(NTAPP)treatment on the bonding strength between dentine and selfetch adhesive and the wettability of dentine surfaces under different treatment times.Methods The plasma jet was operated at an input power of 9 W.Argon was used as the operating gas at a flow rate of 5 L/min.The dentin surface was exposed to the plasma jet(n=6)for various times(0,5,10,15,20 s).After a onestep selfetch adhesive(S3 Bond)was applied to the treated dentine surface,microtensile bonding specimens were made,and the microtensile bonding strength was tested.Then,the dentine surface contact angles were measured after NTAPP treatment for 5,10,15,and 20 s with the same gas flow rate and input power described above.Results Along with the NTAPP treatment time,the dentin immediate bonding strength was significantly increased.The 15 s group showed significantly elevated bonding strength(31.82±2.80 MPa)in contrast to the other groups.The contact angles of each experimental group significantly decreased compared with the contact angles of the negative control group(75.57°±1.45°).The contact angles decreased the most to 33.56°±2.14°with NTAPP treatment for 15 s,and its wettability was the highest.Conclusion NTAPP treatment can significantly increase the wettability of the dentin surface and improve the adhesive strength of the adhesive interface with selfetching adhesive,which is also related to the treatment time.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.21.113.219