检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:凌辉 杜钦君[1] 冯晗 庞浩 杨姝欣 罗永刚[1] LING Hui;DU Qinjun;FENG Han;PANG Hao;YANG Shuxin;LUO Yonggang(School of Electrical and Electronic Engineering,Shandong University of Technology,Zibo 255022,Shandong,China)
机构地区:[1]山东理工大学电气与电子工程学院,山东淄博255022
出 处:《上海交通大学学报》2022年第12期1608-1618,共11页Journal of Shanghai Jiaotong University
基 金:国家自然科学基金面上项目(62076152);山东省自然科学基金面上项目(ZR2020MF096);山东省科技型中小企业创新能力提升工程项目(2021TSGC1109)资助。
摘 要:针对开关磁阻电动机(SRM)在换向时电流跟踪效果不佳造成的转矩脉动问题,提出一种基于五电平变换器的开关磁阻电动机转矩脉动抑制方法.设计一种A、C相或B、D相共用同一桥臂的新型五电平变换器结构,较传统变换器控制更灵活、成本更低.根据SRM的非线性模型重新划分导通区间,优先选择电感变化率较大的相输出转矩,避免换向初期电流峰值过大.针对转速及负载等工况发生较大变化时绕组电流跟踪能力不佳问题,提出基于五电平变换器的直接瞬时转矩控制(DITC)方法,设计低速与高速的DITC导通规则.根据当前转速、转矩误差以及转子位置选择适配的导通方式,实现电动机低速时能够稳定运行,高速时电流能及时跟踪所需电流值,实现转矩脉动的抑制.仿真和实验结果表明:相比于传统DITC,该控制策略能在宽速域下实现转矩与电流脉动的抑制,改善转矩的动态特性.Aimed at the problem of large torque ripple and low efficiency caused by the poor current tracking effect of switched reluctance motor(SRM),a torque ripple reduction method of switched reluctance motor based on a five-level converter is proposed.A novel five-level converter with A and C phases or B and D phases sharing the same bridge arm is designed.Compared with the traditional converter,the control is more flexible and the cost is lower.According to the nonlinear model of SRM,the conduction region is reclassified,and the phase output torque with a large inductance change rate is preferred to avoid excessive peak current at the beginning of commutation.Aimed at the problem of poor winding current tracking ability when the speed and load conditions change greatly,the direct instantaneous torque control(DITC)method based on the five-level converter is proposed,and the DITC conduction rules at low and high speeds are designed.According to the current speed,the torque error,and the rotor position,the appropriate conduction mode is selected to make sure that the motor can run stably at a low speed and the current can track the required value in time at a high speed,so as to realize the reduction of torque ripple.The simulation and experimental results show that compared with the traditional DITC,the control strategy can reduce the torque and current ripple in a wide speed range and improve the dynamic characteristic of the torque.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.225.7.106