结合NASA DEM和AW3D30 DEM的太原市DEM数据融合  

DEM fusion based on NASA DEM and AW3D30 DEM in Taiyuan

作　　者：刘娇 赵尚民[1] LIU Jiao;ZHAO Shangmin(College of Mining Engineering,Taiyuan University of Technology,Taiyuan 030024,China)

机构地区：[1]太原理工大学矿业工程学院,山西太原030024

出　　处：《测绘通报》2022年第11期90-95,共6页Bulletin of Surveying and Mapping

基　　金：国家自然科学基金面上项目(42271432);山西省自然科学基金(201901D111098)。

摘　　要：本文首先以DEM数据为例,将输入数据与参考数据配准至同一像素位置,然后分别将均方根误差和标准差作为参考指标,在不同坡度等级的区域内,通过权重系数从0至1的遍历探寻最佳加权融合系数,从而确定融合方案并进行NASA DEM与AW3D30 DEM的数据融合,最后对融合效果进行定量评价。结果表明:配准前,NASA DEM沿x、y、z方向的位移分别为-2.65、2.41、0.60 m,AW3D30 DEM位移分别为1.04、7.51、-3.33 m;配准后,原始数据各项误差均减小,且NASA DEM的系统误差基本消失。融合DEM相较于NASA DEM,平均误差和均方根误差分别减小了25.0%和36.8%;对于AW3D30 DEM,误差降幅分别为86.5%和13.2%。In this paper,taking DEM data as an example,the input data and the reference data are firstly aligned to the same pixel position,then the root mean square error and standard deviation are taken as reference indicators,and the best weighting fusion coefficients are explored by the traversal process of weighting coefficients from 0 to 1 in the regions of different slope classes.To determine the fusion scheme and perform the fusion of NASA DEM and AW3 D30 DEM,and finally evaluate the fusion effect quantitatively.The results show that before the alignment,the displacements of NASA DEM along x,y,and z directions are-2.65,2.41,and 0.60 m,and the displacements of AW3 D30 DEM are 1.04,7.51,and-3.33 m;after the alignment,all the errors of the original data are reduced,and the systematic errors of NASA DEM disappear.Compared with the NASA DEM,the ME and RMSE of the fused DEM are reduced by 25.0%and 36.8%;for the AW3 D30 DEM,the error reduction is 86.5%,and 13.2%.

关 键 词：NASA DEM AW3D30 DEM 最小二乘法配准 加权融合 太原市 

分 类 号：P23[天文地球—摄影测量与遥感]