检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:陈江 张立松 谭龙胜 贺婷 兀鹏越[2] CHEN Jiang;ZHANG Lisong;TAN Longsheng;HE Ting;WU Pengyue(China Huaneng Group,Ltd.,Beijing 100031,China;Xi’an Thermal Power Research Institute Co.,Ltd.,Xi’an 710032,Shaanxi,China)
机构地区:[1]中国华能集团公司,北京100031 [2]西安热工研究院有限公司,陕西西安710032
出 处:《电网与清洁能源》2023年第2期10-15,共6页Power System and Clean Energy
基 金:华能集团总部科技项目(HNKJ-21-H66)。
摘 要:为准确可靠识别雷击干扰和故障,提出了一种基于扰动电压波形包络图构造积分判据的方法。首先提取母线电压中的扰动电压波形,然后分别拟合扰动电压波形于时间轴上、下方的包络线,进而根据得到的包络线计算积分面积,最后利用波形对称度识别雷击干扰和故障。ATP—EMTP软件仿真计算表明:扰动电压波形在时间轴上、下方的积分相近,可判定为雷击干扰,反之为雷击故障,且所述方法能够避免波形记录装置采样频率低、雷电流幅值和故障点位置等因素的影响,具有很高的鲁棒性。研究结果为工程实际中辨识雷击干扰和故障提供了参考指导。To accurately and reliably identify lightning disturbances and faults,a method for constructing integral criterion based on the disturbance voltage waveform envelope is proposed. Firstly,the disturbance voltage waveform in the bus voltage is extracted,and the envelopes of the disturbance voltage waveform on the upper and lower sides of the time axis are respectively fitted,and then the integral area is calculated according to the obtained envelope,and finally the lightning disturbance and fault are identified by the waveform symmetry.The ATP-EMTP software simulation calculation shows that the integrals of the disturbance voltage waveform on the time axis and below are similar,which can be judged as lightning strike disturbance,otherwise it is a lightning strike fault. The method can avoid the influence of factors such as the low sampling frequency of the waveform recording device,the amplitude of the lightning current and the position of the fault point. It has high robustness. The research results provide reference guidance for the identification of lightning disturbances and faults in engineering practice.
分 类 号:TM863[电气工程—高电压与绝缘技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.127