检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:赵宏刚[1,2] 尹光志[1,2] 黄滚[1,2] 蒋长宝[1,2] ZHAO Honggang;YIN Guangzhi;HUANG Gun;JIANG Changbao(State Key Laboratory of Coal Mine Disaster Dynamics and Control,Chongqing University,Chongqingg 400030,China;School of Resources and Safety Engineering,Chongqing University,Chongqing 400030,China)
机构地区:[1]重庆大学煤矿灾害动力学与控制国家重点实验室,重庆400030 [2]重庆大学资源与安全学院,重庆400030
出 处:《采矿与安全工程学报》2023年第1期135-144,共10页Journal of Mining & Safety Engineering
基 金:国家自然科学基金项目(51674049,51674048)。
摘 要:隧洞开挖过程中主应力方向发生改变,造成围岩应力分布与塑性区随之产生变化,显著影响着隧洞围岩的稳定及支护。以椭圆形隧洞为例,模拟不同主应力方向下隧洞围岩的破坏,基于复变函数和强度准则建立不同主应力方向下不同深度的围岩应力解析解和塑性区模型,结果显示:主应力方向与椭圆形隧洞非共面时,围岩应力呈“斜哑铃状”分布,最大切向应力处于顶底部与侧帮之间的位置,且随着距临空面深度的增大,最大切向应力逐渐靠近水平主应力方向;随着主应力方向与隧洞夹角的增大,洞壁处的最大切向应力集中点由隧洞侧帮逐渐靠近隧洞顶底部,且洞壁破坏范围逐渐减小;随着主应力方向与隧洞夹角的增大,椭圆形隧洞围岩塑性区逐渐远离侧帮中心处,塑性区范围和最大深度逐渐减小。不同主应力方向下围岩塑性区最大深度所处位置平行或近似平行于水平主应力方向。The change of principal stress in the process of tunnel excavation results in the change of stress distribution and plastic zone of surrounding rock,which significantly affects the stability and support of tunnel surrounding rock.In this paper,taking an elliptical tunnel as an example,the failure of surrounding rock under different principal stress directions was simulated.Based on complex variable functions and strength criterion,the analytical solution of surrounding rock stress under different principal stress directions and the plastic zone model were established.The results have shown that the maximum tangential stress is located between the top and bottom and the side wall,and with the increase of the depth from the free surface,the maximum tangential stress gradually approaches the direction of horizontal principal stress.With the increase of the angle between the principal stress direction and the tunnel,the concentration point of the maximum tangential stress at the free face gradually approaches the top and bottom of the tunnel.In addition,the damage region of the sidewall gradually decreases.As the angle between the principal stress direction and the tunnel increases,the plastic zone of the surrounding rock gradually moves away from the center of the sidewall,and the region and maximum depth of the plastic zone gradually decrease.Under different principal stress directions,the maximum depth of plastic zone is parallel or approximately parallel to the horizontal principal stress direction.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.49