SCR催化器失效故障诊断和容错控制方法研究  

Research on Fault Diagnosis and Fault Tolerance Control of SCR Catalytic Converter

在线阅读下载全文

作  者:李明建 胡友耀 黄银龙[1,2] 刘西文 刘庆伟 魏明亮[1,2] LI Mingjian;HU Youyao;HUANG Yinlong;LIU Xiwen;LIU Qingwei;WEI Mingliang(State Key Laboratory of Intelligent Agricultural Power Equipment,Luoyang 471039,China;Luoyang Tractor Research Institute Co.,Ltd.,Luoyang 471039,China)

机构地区:[1]智能农业动力装备全国重点实验室,河南洛阳471039 [2]洛阳拖拉机研究所有限公司,河南洛阳471039

出  处:《拖拉机与农用运输车》2024年第5期35-37,42,共4页Tractor & Farm Transporter

基  金:中国机械工业集团有限公司青年科技基金项目(QNJJ-PY-2022-39)。

摘  要:针对SCR催化器由于老化、硫中毒等因素出现的失效故障,基于转化效率对其进行故障评估,并引入了一种失效因子,用来表征SCR催化器的失效程度。在此基础上,对不同工况下的尿素喷射量进行修正,以保证尾气排放符合OBD限值要求。最后,以某型号6缸高压共轨柴油机为对象,加装已经部分老化失效的后处理系统进行台架验证。试验结果表明:通过失效因子修正后,稳态循环工况下,发动机尾气排放为1.4 g/(kW·h),瞬态循环工况下,排放为1.77 g/(kW·h),与催化器失效前的值基本相当,均低于非道路国四阶段法规要求,有效地降低了催化器失效对SCR系统造成的负面影响。Aiming at the failure of SCR catalyst due to aging,sulfur poisoning and other factors,this paper evaluates its failure based on conversion efficiency,and introduces a failure factor to characterize the failure degree of SCR catalyst.On this basis,the urea injection amount under different working conditions is modified to ensure that the exhaust emissions meet the OBD limit.Finally,taking a type of 6-cylinder high pressure common rail diesel engine as an object,a post-processing system which has been partially aged and failed is installed to carry out bench verification.The test results show that:After the failure factor is corrected,emission of engine exhaust is 1.4 g/(kW·h)under steady cycle condition and 1.77 g/(kW·h)under transient cycle condition,which is basically equivalent to the value before the catalyst failure,and both are lower than the four-stage regulations of non-road countries,effectively reducing the negative impact of catalyst failure on SCR system.

关 键 词:SCR系统 尿素喷射 故障诊断 容错控制 

分 类 号:S232.3[农业科学—农业机械化工程]

 

参考文献:

正在载入数据...

 

二级参考文献:

正在载入数据...

 

耦合文献:

正在载入数据...

 

引证文献:

正在载入数据...

 

二级引证文献:

正在载入数据...

 

同被引文献:

正在载入数据...

 

相关期刊文献:

正在载入数据...

相关的主题
相关的作者对象
相关的机构对象