检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:姚慧丹 杜忠金 杜宇 赵洪滢 孙翀[1] YAO Huidan;DU Zhongjin;DU Yu;ZHAO Hongying;SUN Chong(Qingdao University of Science and Technology,Qingdao 266061,China)
机构地区:[1]青岛科技大学橡塑材料与工程教育部重点实验室,山东青岛266061 [2]青岛科技大学中德科技学院,山东青岛266061
出 处:《橡胶工业》2025年第4期261-266,共6页China Rubber Industry
基 金:中德青年科学院一期资助项目(20-12-3-1-hz-2)。
摘 要:采用多壁碳纳米管(MWCNTs)/炭黑N330填充天然橡胶/顺丁橡胶并用胶,研究MWCNTs用量对并用胶挤出流变特性的影响。结果表明:随着MWCNTs用量的增大,并用胶的门尼粘度增大,应力松弛速率减小;随着剪切速率的增大,并用胶(熔体)的稳态粘度减小,剪切应力近似呈线性增大,挤出胀大比和挤出物畸变程度增大;当固定剪切速率时,随着MWCNTs用量的增大,并用胶的挤出胀大比减小;当剪切速率为50 s^(-1)时,MWCNTs用量对并用胶的挤出物表面形貌的影响较小,当剪切速率为200 s^(-1)时MWCNTs用量为7份的并用胶的挤出物表面呈扭曲状态,当剪切速率达到500 s^(-1)时各MWCNTs用量的并用胶的挤出物表面均呈扭曲状态。Natural rubber(NR)/butadiene rubber(BR)blends were filled with multi-walled carbon nanotubes(MWCNTs)/carbon black N330,and the effect of the MWCNTs amounts on the extrusion rheological properties of the blends was studied.The results showed that as the MWCNTs amounts increased,the Mooney viscosity of the blend increased,and the stress relaxation rate decreased.As the shear rate increased,the steady viscosity of the blend(melt)decreased,the shear stress approximately increased linearly,and the extrusion swelling ratio and the distortion degree of the extrudate increased.At a fixed shear rate,the extrusion swelling ratio of the blend decreased with the increase of the MWCNTs amount.When the shear rate was 50 s^(-1),the MWCNTs amounts had little effect on the surface morphologies of the extrudates of the blends.When the shear rate was 200 s^(-1),the surface of the extrudate of the blend with 7 phr MWCNTs exhibited a twisted state.When the shear rate reached 500 s^(-1),the surfaces of the extrudates of the blends with different MWCNTs amounts displayed twisted states.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.171