检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:葛少博 刘卫国[1] 周顺[1] 李世杰[1] 杨鹏飞[1] GE Shaobo;LIU Weiguo;ZHOU Shun;LI Shijie;YANG Pengfei(Shaanxi Province Key Laboratory of Thin Films Technology and Optical Test,School of Photoelectric Engineering,Xi'an Technological University,Xi'an 710021,China)
机构地区:[1]西安工业大学光电学院陕西省薄膜技术与光学检测重点实验室,陕西西安710021
出 处:《应用光学》2019年第2期342-348,共7页Journal of Applied Optics
基 金:国家基础研究项目(JCKY2016208A002);先进制造项目(41423020111);国家自然科学基金(51502232);陕西省高校科协青年人才托举计划项目(20160122);西安工业大学院长基金(15GDYJY03)
摘 要:为了在光学薄膜中引入连续轮廓的微结构,综合利用薄膜的干涉效应与微结构的折反射、衍射效应,提出一种薄膜光学微结构的制备工艺。基于时域有限差分方法设计了具有可见光波段减反射特性的薄膜光学锥形光栅;采用单点金刚石车削技术,结合纳米压印与电感耦合等离子体刻蚀技术,在SiNx薄膜中制备出高1.6μm,周期4.1μm的锥形光栅;在可见光波段,SiNx薄膜光学锥形光栅的平均反射率为5.7%,反射率的实验检测结果与仿真计算结果达到很高的一致性;当入射光角度在30°以内,薄膜光学锥形光栅的减反特性表现出对光波入射角度的不敏感性。该制备工艺突破了单点金刚石车削技术的材料局限,将连续轮廓的微结构的直接形成工艺拓展至介质薄膜当中,实现了宽光谱、宽入射角度的减反射。In order to introduce a continuous contoured microstructure into the optical thin film,the refraction,diffraction of the microstructures and the interference of the thin film were comprehensively utilized,and the preparation process of the thin film optical microstructure was proposed.The thin film optical tapered grating with anti-reflection characteristics in visible light was designed based on the finite difference time domain method.A tapered grating having a height of 1.6μm and a period of 4.1μm was prepared in the SiNx film by single point diamond turning technology,combined with nanoimprint lithography and inductively coupled plasma etching,In the visible band,the SiNx thin film optical tapered grating had an average reflectance of 5.7%,and the experimental results of the reflectance were highly consistent with the simulation results;when the incident angle was within 30°,the anti-reflection characteristic of the thin-film optical tapered grating exhibited an insensitivity to the incident angle of the light waves.It is indicated that the preparation process breaks through the material limitations of the single point diamond turning technology,it can extend the direct formation process of the continuous contour microstructure into the dielectric thin film,and can achieve the anti-reflection of wide spectrum and wide angle.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222