Comparative Studies on Microstructure and Mechanical Properties of Granulated Blast Furnace Slag and Fly Ash Reinforced AA 2024 Composites  

作　　者：Inampudi Narasimha Murthy Nallabelli Arun Babu Jinugu Babu Rao 

机构地区：[1]Department of Metallurgical Engineering, Andhra University, Visakhapatnam, India

出　　处：《Journal of Minerals and Materials Characterization and Engineering》2014年第4期319-333,共15页矿物质和材料特性和工程（英文）

摘　　要：Composites are most promising materials of recent interest. Metal matrix composites (MMCs) possess significantly improved properties compared to unreinforced alloys. There has been an increasing interest in composites containing low density and low cost reinforcements. In view of the generation of large quantities of solid waste by products like fly ash and slags, the present expensive manner in which it is discarded, new methods for treating and using these solid wastes are required. Hence, composites with fly ash and granulated blast furnace (GBF) slag as reinforcements are likely to overcome the cost barrier for wide spread applications in automotive and small engine applications. In the present investigation, AA 2024 alloy-5 wt% fly ash and GBF slag composites separately were made by stir casting route. Phase identification and structural characterization were carried out on fly ash and GBF slag by X-ray diffraction studies. Scanning electron microscopy with energy dispersive X-ray spectroscopy EDS was used for microstructure analysis. The hardness and compression tests were carried out on all these alloy and composites. The SEM studies reveal that there was a uniform distribution of fly ash and GBF slag particles in the matrix phase and also very good bonding existed between the matrix and reinforcement. Improved hardness and mechanical properties were observed for both the composites compared to alloy;this increase is higher for Al-fly ash composite than Al-GBF slag composite.Composites are most promising materials of recent interest. Metal matrix composites (MMCs) possess significantly improved properties compared to unreinforced alloys. There has been an increasing interest in composites containing low density and low cost reinforcements. In view of the generation of large quantities of solid waste by products like fly ash and slags, the present expensive manner in which it is discarded, new methods for treating and using these solid wastes are required. Hence, composites with fly ash and granulated blast furnace (GBF) slag as reinforcements are likely to overcome the cost barrier for wide spread applications in automotive and small engine applications. In the present investigation, AA 2024 alloy-5 wt% fly ash and GBF slag composites separately were made by stir casting route. Phase identification and structural characterization were carried out on fly ash and GBF slag by X-ray diffraction studies. Scanning electron microscopy with energy dispersive X-ray spectroscopy EDS was used for microstructure analysis. The hardness and compression tests were carried out on all these alloy and composites. The SEM studies reveal that there was a uniform distribution of fly ash and GBF slag particles in the matrix phase and also very good bonding existed between the matrix and reinforcement. Improved hardness and mechanical properties were observed for both the composites compared to alloy;this increase is higher for Al-fly ash composite than Al-GBF slag composite.

关 键 词：Aluminum Alloys MMCS FLY Ash BLAST FURNACE SLAG STIR Casting 

分 类 号：R73[医药卫生—肿瘤]