A centrifugal pump with a specific speed ns=67 is considered in this study to investigate the impact of blade cutting(at the outlet edge)on the fluid-induced noise,while keeping all the other geometric parameters unch...
As an important parameter of compressor impeller, the design value of blade outlet backsweep angle has a great influence on the performance of impeller. In this paper, six impellers with blade outlet backsweep angle ...
the Scientific Research Project of Inner Mongolia University under Grant No.NJZY19075.
According to current solar power research,both the generating unit’s minimum start-up speed and power generation system’s minimum flow rate for operation decrease with the increase in the impeller solidity.Ideally,a...
Semnan University for the financial support of this research(grant number 845)。
Mixing efficiency in two-phase gas–liquid agitated vessel is one of the important challenges in the industrial processes.Computational fluid dynamics technique(CFD)was used to investigate the effect of four different...
A series of numerical simulations of turbulent single-phase flows are performed to understand the flow and mixing characteristics in a laboratory scale flotation tank.Four impeller blade shapes covering a wide range o...
The flow characteristics of the centrifugal fans with different blade outlet angles are basically discussed on steady and unsteady simulations for a rectangular casing fan. The blade outlet angles of the impellers are...
Supported by National Natural Science Foundation of China(Grant No.51239005);Priority Academic Program Development of Jiangsu Higher Education Institutions(PAPD)
As the critical component, the impellers of the slurry pumps usually have blades of a large thickness. The increasing excretion coefficient of the blades affects the flow in the impeller resulting in a relatively high...
In this paper, the transient behavior of a low specific speed centrifugal pump with straight blades during shutting down is studied through the experimental test, theoretical calculation, and numerical simulation. The...
supported by National Outstanding Young Scientists Founds of China (Grant No. 50825902);National Key Technology R&D Program of China (Grant No. 2008BAF34B15);National Natural Science Foundation of China (Grant No. 51079062);Jiangsu Provincial 333 High-level Personal Training Project of China;Jiangsu Provincial Six Talent Peak of China
The double blade pump is widely used in sewage treatment industry,however,the research on the internal flow characteristics of the double blade pump with particle image velocimetry(PIV) technology is very little at ...
Project(NRF-2010-013-D00007) supported by the National Research Foundation of Korea;Work finacially supported by the 2010 Research Professor Fund of Gyeongsang National University,Korea
Multistage centrifugal impellers with four different skew angles were investigated by using computational fluid dynamics.The purpose of this work is to investigate the influences of lean angle at the blade tip of the ...