相关期刊:《Journal of Minerals and Materials Characterization and Engineering》《Advances in Manufacturing》《Acta Metallurgica Sinica(English Letters)》《China Foundry》更多>>
National Natural Science Foundation of China(No.11602233)。
The aluminum matrix syntactic foam was fabricated by pressure infiltration technique,and the filling material is syntactic foam material with fly ash cenosphere as the main component and polyurethane foam as the binde...
Fly Ash Cenospheres(FACs)are obtained from the coal power plants in the form of hollow spherical particles by burning the coal.FAC was started to use in early 1980-1985 as lightweight filler material in producing comp...
The increased expectation of automotive, aviation and marine industries pertaining to the enhanced properties and their use in elevated temperature conditions and also corrosive environments leads to the development o...
supported by the Open Fund (No.OGE201702-07) of Key Laboratory of Oil and Gas Equipment,Ministry of Education (Southwest Petroleum University);the Key Research and Development Project of Shandong Province (No.2016GGX102041);the Natural Science Foundation of Shandong Province (No.ZR2017LEM004);the Fundamental Research Funds for the Central Universities of China (No.18CX02091A)
The fly ash cenosphere/AZ91D composites were successfully prepared and isothermally heat-treated at different tem- peratures for different time. The effects of semi-solid isothermal heat treatment on the microstructur...
Aluminum-based metal matrix composites (MMCs) are considered in several technological applications owing to their enhanced mechanical properties when compared with monolithic metals. Research on the mechanical propert...
Fly ash has congregated considerable attention as a potential reinforcement for aluminum matrix composites(AMCs)to enhance selective properties and reduce the cost of fabrication.However,poor machinability of such AMC...
Financial supports from various funding agencies Tata Steel, Jamshedpur, Department of Science and Technology, New Delhi, Council of Scientific and Industrial Research, New Delhi and Board of Research on Nuclear Science, Bombay for the present study are gratefully acknowledged
The cenosphere dispersed Ti matrix composite was fabricated by powder metallurgy route, and its wear and corrosion behaviors were investigated. The results show that the microstructure of the fabricated composite cons...
Titanium cenosphere syntactic foam of varying relative densities with coarse cenospheres was developed through powder metallurgy route at lower compaction loads. The cold compaction load was varied in the range of 60 ...
Cenospheres are produced in very large amount in thermal power plants. They are always looked upon as fillers used to reduce the density and cost of the polymer. If cenosphere particles are allowed to remain properly ...
supported by Postdoctoral Science Foundation of China (20080431069)
Precursors of binary alloy (Fe112C0112, Fel/2Ni1/2, Ni1/2Co1/2, hereinafter referred to as FeCo, FeNi, NiCo) coated cenospheres were prepared by heterogeneous precipitation under optimized conditions. Magnetic binar...