supported by the National Natural Science Foundation of China(No.51804232);Beijing Municipal Natural Science Foundation(No.2212041);supported by the Interdisciplinary Research Project for Young Teachers of USTB(Fundamental Research Funds for the Central Universities)(FRF-IDRY-20-020);GIMRT Program of the Institute for Materials Research,Tohoku University(202303-RDKGE-0518).
Enhancing homogenization efficiency and hot-workability is the key issue for wrought superalloys in the industry.A novel approach for simultaneous accelerating the homogenization kinetics and improving hot-workability...
Funded by the National Natural Science Foundation of China(No.U1904188)。
A simplex centroid design method was employed to design the gradation of recycled coarse aggregate.The bulk density was measured while the specific surface area and average excess paste thickness were calculated with ...
supported by the National Key R&D Program of China(Nos.2021YFB3700601 and 2019YFA0705304);the IMR Innovation Fund(No.2023-PY08).
The hot deformation behavior of a newly developed Ni–W–Cr superalloy for use in 800℃molten salt reactors(MSRs)was looked into by isothermal compression tests in the temperature range of 1050–1200℃with a strain ra...
supported by the National Natural Science Foundation of China(Grant Nos.52305361,51775194,52090043);China Postdoctoral Science Foundation(2023M741245);the National Key Research and Development Program of China(2022YFB3706903).
Hot deformation is a commonly employed processing technique to enhance the ductility and workability of Mg alloy.However,the hot deformation of Mg alloy is highly sensitive to factors such as temperature,strain rate,a...
Purging plug refractories in China typically contain around 3 mass% of super-fine chromium oxide in the matrix in order to improve the performance of the purging plugs, primarily, slag corrosion and wear resistance. A...
Funded by the National Natural Science Foundation of China(No.52008046);Young Elite Scientists Sponsorship Program from JSAST(No.TJ-2023-024);Postgraduate Research&Practice Innovation Program of Jiangsu Province(No.KYCX21_2848)。
This study aims to investigate the feasibility of using decoration waste powder(DWP)as a partial replacement for fly ash(FA)in the preparation of geopolymer masonry mortar,and to examine the effect of different DWP re...
This research explores the utilization of wheat straw ash(WSA),an agricultural by-product enriched with amorphous silica,as a partial cement replacement in concrete production.The WSA content ranged from 4%to 16%by ma...
The financial support from the National Natural Science Foundation of China(Grant No.52022112);the Fundamental Research Funds for the Central South University(Grant No.2023ZZTS0366)are acknowledged and appreciated.The authors are also grateful for the help from Dr.Ji Zhao of China University of Mining and Technology.
Water spewing and muck plugging often occur during earth pressure balance(EPB)shield machines tunnelling in water-rich sandy strata,even though the conventional foam has been employed to condition sandy soils.In this ...
funded by the National Natural Science Foundation of China(NSFC)under Grant No.211021180360;the Transportation Science and Technology in Shaanxi Province under Grant No.KY17-02.
Good compatibility between waterborne epoxy resin(WER)modifier and styrene-butadiene rubber(SBR)latex modified asphalt emulsion(SBRE)is an essential premise for good pavement performance of WER and SBR latex composite...
This experimental study aims to examine the influence of many crucial parameters on the workability and compressive strength of Ready-Mix Concrete (RMC). The study utilized two distinct varieties of superplasticizers ...