Natural Science Foundation of Shandong Province of China(ZR2023QE193)。
The microstructures and mechanical properties of Al-8.3Zn-3.3Cu-2.2Mg alloys prepared via hot extrusion and liquid forging methods were investigated.Results show that based on DEFORM simulation analysis,the optimal ho...
Project (2006AA03Z523) supported by the National High-tech Research and Development Program of China
The microstructural evolution and composition distribution of an Al-Zn-Cu-Mg-Sc-Zr alloy during homogenization were investigated by optical microscopy(OM),scanning electron microscopy(SEM),energy dispersive spectr...
Project(2006AA03Z523) supported by the National High-tech Research and Development Program of China
The mechanical properties and stress corrosion cracking (SCC) resistance of an Al-Zn-Cu-Mg-Sc-Zr alloy under different aging conditions were investigated. The dependence of microstrueture and mechanical properties o...
Project(2006AA03Z523) supported by the National High-Tech Research and Development Program of China
The deformation behavior of a new Al-Zn-Cu-Mg-Sc-Zr alloy was investigated with compression tests in temperature range of 380?470 ℃ and strain rate range of 0.001-10 s-1 using Gleeble 1500 system, and the associated ...
Project(50171019) supported by the National Natural Science Foundation of China;Project(1063293) supported by Shenyang Science and Technology Foundation, China
The 5Cu40Zn55Al and 15Cu20Zn65Al alloys were prepared in the Al-Zn-Cu system. There exist the metastable phases ε and θ in the two alloys after homogenization treatment and furnace cooling,respectively. It is shown ...
The room temperature phase diagram of Al-Zn-Cu system is the important basis for judging the phase constituents of the materials at the usage condition. New results about the room temperature phase diagram of the low ...