the support by the National Natural Science Foundation of China(Nos.51208098 and 51678144);the National Basic Research Program of China(No.2015CB655100);the Natural Science Foundation of Jiangsu Province(No.BK20161420);Industry-University Research Cooperative Innovation Fund of Jiangsu Province(No.BY2013091)
Electrochemical impedance spectroscopy, cyclic potentiodynamic polarization measurements, and scanning electron microscopy in conjunction with energy-dispersive X-ray spectroscopy were used to investigate the influenc...
supported by the National Natural Science Foundation of China (Grant nos. 51471017 and 51431007);the National 973 Program of China (Grant no. 2012CB619403)
It has been well accepted that the martensites in quenched carbon steels exhibit two typical morphologies which are closely dependent on the carbon content, i.e. lath martensite in low carbon steels and lenticular mar...
supported by the National Science Foundation of China (Nos.50701044 and 50890171);the Ministry of Science and Technology of China (No.2005CB623604)
This study reports the significantly enhanced aluminizing behaviors of a low carbon steel at temperatures far below the austenitizing temperature, with a nanostructured surface layer produced by surface mechanical att...
This work was supported by the Major State Basic Research Development Program of China(973 Program)under the contract number of 2004CB619108;the National Natural Science Foundation of China(No.50574018);the NECT-04-0278 Project of the Ministry of Education of China.
In the present paper, low carbon steel strips with different phosphorus contents were produced using a twin roll strip casting process. The solidification structure was studied and its features were analyzed in detail...
This work was financially supported by the "973" Key Foundation of China (No. GJ998061500)
The microstructures of low carbon steel before, during and after rollingdeformation of each stand were observed using optical microscope. The result showed that themicrostructures were very fine after six passes rolli...
This work was financially supported by the National Science Foundation of China(No.59971011) and the "973" Item of China(No.1999
In order to investigate the effect of hydrogen attack degree on acoustic emission(AE) behavior of low carbon steel during tensiling, specimens made of Low carbon steel was exposed to hydrogen gas of 18 MPa at 450 and ...