检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
出 处:《药学学报》2007年第4期445-449,共5页Acta Pharmaceutica Sinica
摘 要:To study the rheological properties of sucrose acetate isobutyrate(SAIB) in situ gel and the influencing factors.Measurements of shear stress and viscosity were carried out at different shear rate.The rheological properties of SAIB solution were similar to those of Newtonian fluid.The factors such as the type of solvent,concentration,additive,drug and temperature had effect on the rheological properties.Ethanol was a suitable solvent compared with ethyl lactate and N-methylpyrrolidone(NMP).The solution viscosity of SAIB was reduced from 1.29 to 0.11 Pa·s with only increasing the content of ethanol from 10% to 20%.Polylactic acid(PLA) and risperidone could increase the intermolecular force and viscosity.However,adding 10%(w/w) PLA,the initial release of risperidone was reduced from 20.2% to 3.5%.The solution viscosity reduced significantly by stepping up the temperature.The results obtained support the using of SAIB is satisfactorily injectable in situ gel formulation.To study the rheological properties of sucrose acetate isobutyrate (SAIB) in situ gel and the influencing factors. Measurements of shear stress and viscosity were carried out at different shear rate. The rheological properties of SAIB solution were similar to those of Newtonian fluid. The factors such as the type of solvent, concentration, additive, drug and temperature had effect on the rheological properties. Ethanol was a suitable solvent compared with ethyl lactate and N-methylpyrrolidone (NMP). The solution viscosity of SAIB was reduced from 1.29 to 0. 11 Pa · s with only increasing the content of ethanol from 10% to 20%. Polylactic acid (PLA) and risperidone could increase the intermolecular force and viscosity. However, adding 10% (w/w) PLA, the initial release of risperidone was reduced from 20. 2% to 3.5%. The solution viscosity reduced significantly by stepping up the temperature. The results obtained support the using of SAIB is satisfactorily injectable in situ gel formulation.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.249