电动钉枪性能试验台植入组件移动板设计  

Design of the Moving Plate Implantable Components of Performance Experimental Platform for Electric Nail Gun

作　　者：曹忠伟 高庚员[2] 梁伟青[2] 翁泽宇[2] 

机构地区：[1]宁波永发集团有限公司,浙江宁波315813 [2]浙江工业大学机械工程学院,浙江杭州310014

出　　处：《轻工机械》2010年第2期96-99,共4页Light Industry Machinery

基　　金：浙江省先进制造技术与装备重中之重学科开放研究基金项目(AMT200506-017)

摘　　要：根据电动钉枪性能试验台的工作原理,植入组件移动板的设计要求是:在有足够刚度的前提下,质量尽可能小。文章在对移动板进行受力分析的基础上,针对方形移动板和蝴蝶型移动板2种方案,用有限元分析了其在外载荷作用下的变形,对蝴蝶型移动板设计方案给予了肯定。然后,研究了在外载荷作用下,蝴蝶型移动板的厚度对其变形量的影响,最终得出较为合理的移动板设计方案。According to the working Principle of the performance experimental platform for the electric nail gun, the design requirement of the implantable components of the moving plates is ： under the premise of sufficient stiffness, try to make the quality as small as possible, In this paper, on the basis of force analysis of the moving plate , based on two schemes of the square moving plate and the butterfly-shaped moving plate, make analysis of the deformation with finite element method when they are under the outer loads. And then the butterfly-shaped design of the moving plate is affirmed. Afterward, study the influence of the thickness of the butterfly-shaped moving plates to the deformation when they are under the outer loads. Finally, a more reasonable design scheme of the moving plate is obtained.

关 键 词：电动工具 电动钉枪 试验台 有限元分析 移动板 设计方案 

分 类 号：TS914.5[轻工技术与工程]