检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李围[1,2]
机构地区:[1]贵州大学土木建筑工程学院,贵阳550003 [2]贵州大学桥梁与隧道工程研究中心,贵阳550003
出 处:《路基工程》2010年第2期12-14,共3页Subgrade Engineering
基 金:贵州大学引进人才项目(X065002)
摘 要:采用梁-地层弹簧模型,进行了在铁路列车荷载作用下盾构隧道纵向力学行为有限元分析。结果表明:当等效的管片环数较多时,环数的变化对其纵向刚度的影响很小,两侧计算边界取1倍上部荷载作用长度;当盾构隧道的埋深大于2倍隧道外径时,纵向内力和变形很小,满足强度和刚度要求,其纵向设计不需特殊考虑;随着埋深的增加,列车荷载所产生的管片纵向附加内力和变形减小。With beam-shell spring model, this paper carries out finite element analysis on vertical mechanical behavior of shield tunnel under the effect of trains load. The result indicates that when there are many equivalent segment joints, the changes of joints has little influence on vertical rigidity, so it just takes the length of upper load part on both sides for calculation; when the buried depth of shield tunnel is greater than twice outer diameter, vertical inner force and deformation are little, which can satisfy the requirement of strength and rigidity, so vertical design need no special consideration; with the increase of buried depth, vertical additional inner force and deformation of segment caused by trains load will decrease.
关 键 词:铁路股道 盾构隧道 管片结构 梁-地层弹簧模型 纵向力学行为
分 类 号:U455.43[建筑科学—桥梁与隧道工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117