检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:朱爱斌[1,2] 路新春[1] 张浩[2] 陈渭[2] 谢友柏[2]
机构地区:[1]清华大学摩擦学国家重点实验室,北京10084 [2]西安交通大学现代设计及转子轴承系统教育部重点实验室,西安710049
出 处:《西安交通大学学报》2011年第12期111-116,共6页Journal of Xi'an Jiaotong University
基 金:国家杰出青年科学基金资助项目(50825501);国家自然科学基金创新研究群体科学基金资助项目(51021064);国家科技重大专项资助项目(2008ZX02104-001)
摘 要:采用准连续介质力学方法研究了铜化学机械抛光过程的机械作用材料去除机理.模拟了不同大小磨粒在单晶铜工件上的磨削过程,分析了切削过程中工件内部材料变形、切屑的形成以及工件内部应力分布和切削力变化.研究结果表明,工件内部材料沿着与切削方向约45°变形形成剪切带,在剪切带区域伴随有位错、滑移等现象产生.磨粒较小时加工后的表面质量较差,磨粒较大时加工质量较好,但会造成工件内部较大的塑性变形与更深的残余应力分布.磨粒尺寸变化对于切向切削力影响不大.Quasi-continuum method is adopted to investigate the material removal mechanism of chemical mechanical polishing of copper.The grinding process on the single crystal workpiece of abrasive particles of different sizes is simulated to analyze material deformation,stress distribution in the workpiece,chip formation and cutting force fluctuation.The result shows that shear zone is formed at 45° to the polishing direction with dislocations and sliding in the bulk.Smaller abrasive particles result in bad surface quality,while larger particles generate larger plastic deformation and deeper residual stress layer.Particle size exerts little influence on the tangential cutting force.
分 类 号:TH117.3[机械工程—机械设计及理论]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.249