检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]燕山大学电气工程学院,河北秦皇岛066004 [2]燕山大学河北省测试计量技术与仪器重点实验室,河北秦皇岛066004
出 处:《光电工程》2012年第3期46-51,共6页Opto-Electronic Engineering
基 金:国家科技重大专项(2010ZX04017-013);河北省科学技术研究与发展计划项目(10212152);秦皇岛市科学技术研究与发展计划(201001A077);河北省重点实验室开放基金项目
摘 要:针对回转类锻件视觉测量系统标定问题,本文提出了一种基于被测对象自约束特征的系统参数自标定方法。首先,利用筒类锻件和支撑轴的回转特性,通过共轴截面曲线圆环点和极线约束建立摄像机系统内参数约束方程,求解测量系统所有内部参数。其次,在求得的内参数矩阵的基础上,通过锻件回转轴和截面图像的成像特点建立测量系统外参数方程,求解测量系统外部参数。实验结果表明,该方法只需利用被测对象自身几何约束,不需任何标定板和标定块,标定过程简单有效。Aiming at the difficulty of single camera system calibration used in cylinder-shaped large forging parts measurement, a new self-calibration method was proposed based on self constraint of the target cylindershaped object; the inner and outer parameters of the measurement system were achieved from a single image. Firstly, taking advantage of the rotation characteristics of the cylinder-shaped large forging parts and the supporting shaft, inner parameter constraint equations were established based on circular points and epipolar constraint derived from images of cross sections. And then the full inner matrix of the measurement system was solved using the constraint equations. Secondly, the outer parameter equations were established using the image of rotation axis and cross sections as well as the inner parameters, and the outer parameters were achieved. Experimental results verified the convenience and effectiveness of the proposed method
分 类 号:TP391[自动化与计算机技术—计算机应用技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222