造纸法再造烟叶单独制丝关键工序加工条件对加工质量的影响  

Studies on Key Processing Conditions for Separate Processing of Paper-making Process Reconstituted Tobacco

作　　者：邓国栋[1] 席年生[1] 李洪涛[2] 边腾飞[3] 刘德虎[2] 徐大勇[1] 堵劲松[1] 张玉海[1] 

机构地区：[1]郑州烟草研究院烟草行业烟草工艺重点实验室 [2]山东中烟工业有限责任公司 [3]浙江中烟工业有限责任公司,杭州市西湖区科海路118号310024

出　　处：《烟草科技》2014年第3期9-13,共5页Tobacco Science & Technology

基　　金：国家烟草专卖局中式卷烟制丝生产线重大专项"基于造纸法再造烟叶特性的制丝工艺技术研究"[110201101012(zs-01)]

摘　　要：为分析造纸法再造烟叶单独制丝关键工序加工条件对加工质量的影响情况,研究了造纸法再造烟叶切丝和烘丝工序加工条件对加工质量的影响。结果表明:①随切丝机刀门压力增大,再造烟叶丝跑片比例减少、粘连并条比例增加;切丝宽度与刀门压力无明显线性关系,刀门压力过低,切丝合格率下降;②随切丝过程物料含水率增加,再造烟叶丝跑片比例略有减少、粘连并条比例增加,飞灰情况逐渐减轻;切丝宽度和宽度合格率与物料含水率无明显线性关系;③随烘丝加工强度的增加,烘后再造烟叶丝卷曲度增加、填充值略有增加。Key processing conditions for separate processing of paper-making process reconstituted tobacco, including cutting and drying parameters on the processing quality of the same were studied. The results indicated that： 1） Along with the increase of mouthpiece pressure in tobacco cutter, the percentage of uncut scraps in cut rag reduced, while the percentage of stuck strands raised. There was no obvious linear correlation between cut width and mouthpiece pressure, however, the qualified rate of cut tobacco decreased if the pressure of mouthpiece was too low. 2） With the increase of moisture content in tobacco during cutting, the percentage of uncut scraps after cutting reduced slightly and the fly ash gradually diminished, while the percentage of stuck strands increased. Cut width or qualified rate had no obvious linear correlation with the moisture content in tobacco. 3） With the increase of processing intensity, the dried cut rag crimped and its filling power increased slightly.

关 键 词：造纸法再造烟叶 跑片 粘连并条 卷曲度 填充值 

分 类 号：TS433[农业科学—烟草工业]